Kenmore Dishwasher 587.15189404 (58715189404, 587 15189404) Parts

NOTE:  Wheels are no longer included with this part.

Replaces a rusty, cracked, or damaged dishwasher upper rack. Restores smooth gliding and secure loading for cups and bowls on the top level.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

White half-width cup shelf for dishwasher upper rack. Replaces cracked, broken, or missing shelves that hold cups and small items during wash cycles.

Black outer door panel for your dishwasher. Replaces cracked, dented, or discolored panels to restore your appliance's appearance. Direct fit.

Replacement wire harness for dishwashers. Connects control board to power components. Replace if wires are burned, melted, frayed, or connectors damaged.

Mounting screw for dishwasher assembly. Secures internal components and panels. Replace if missing, stripped, or corroded during maintenance or repair.

Secures dishwasher wire harness and prevents moisture from reaching the dispenser assembly. Replace if cracked, loose, or causing electrical issues.

Replacement mounting brace for dishwashers. Secures internal components in place. Order a new brace if yours is bent, cracked, or missing.

Replacement care guide and operating manual for your dishwasher. Provides setup, usage, and maintenance instructions if original was lost or damaged.

This is a genuine replacement screw used to secure appliance components and panels, restoring proper fit and function. It's a simple, reliable fastener for repair and maintenance tasks. What it does:

• Secures panels, brackets, trim, or internal components to restore stable assembly
• Replaces a stripped, missing, or rusted screw that prevents proper fastening
• Helps eliminate rattles or loose parts caused by worn fasteners
• Works where the OEM-specified screw is required for correct fit

• Use the correct screwdriver or bit to avoid stripping the head
• Hand-start the screw to ensure correct alignment before tightening
• Tighten only until snug—do not over-torque to avoid damage
• Disconnect power to the appliance before accessing internal components

Dishwasher owner's manual and care guide with operating instructions, maintenance tips, and troubleshooting information for your model.