Kenmore Refrigerator 596.57043600 (59657043600, 596 57043600) Parts

This black facade is the exterior trim panel that restores the front appearance of your range/oven or microwave assembly and provides a finished surface around controls and openings. It refreshes the appliance's look and covers internal components. What it does:

• Replaces a cracked, scratched, faded, or dented front trim to improve appliance appearance
• Covers and protects control-area openings and edges from spills and debris
• Helps maintain proper alignment and fit of adjacent trim and control components
• Restores the original finished surface that users touch and see daily

• Disconnect power to the appliance before starting any repair to avoid shock
• Remove adjacent trim or control components as needed to access mounting points; keep track of fasteners and hardware
• Handle the facade carefully to avoid scratching the finish during installation

This air block is a small plastic baffle that helps direct and control airflow inside the appliance, maintaining even temperatures between compartments and improving overall cooling performance. What it does:

• Channels or blocks internal air flow to balance temperatures between compartments
• Helps prevent warm or cold spots caused by unrestricted airflow
• Reduces the chance of frost buildup from misdirected airflow
• Works with the appliance's venting system to maintain consistent cooling

• Disconnect power to the appliance before starting any service
• Handle the plastic part gently to avoid cracking; align tabs/slots before snapping into place
• No special calibration is usually required; verify airflow and temperature after reassembly

The Electronic Control Board is an OEM part for Whirlpool refrigerators. This part controls and manages various functions of the refrigerator.

Causes of a bad control board can include electrical surges, moisture damage, or general wear and tear over time. 

Symptoms of a bad control board include:

• Refrigerator not cooling properly
• Unresponsive control panel
• Error codes displayed on the interface
• Inconsistent temperature maintenance

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This door hinge restores smooth, controlled door movement and a tight, secure close. Replace a bent or worn hinge to correct doors that sag, bind, or won't stay closed, helping your appliance seal properly and perform as designed.

• Supports and guides the door through its full range of motion
• Helps keep the door aligned so the gasket compresses evenly for a proper seal
• Controls closing action and stop position to protect the door and frame
• Common symptoms: door won't close flush, sags, pops open, or moves roughly/squeaks

What's included: 1 door hinge assembly Installation notes:

• Disconnect power at the breaker and allow the appliance to cool completely before servicing
• Support the door; follow the service manual for door removal. Engage hinge locks or use retaining pins if equipped
• Transfer any screws/brackets from the old hinge to the new and install on the correct side if the design is side-specific
• Ensure the latch engages and the gasket seals uniformly all around