Kenmore Refrigerator 596.77532702 (59677532702, 596 77532702) Parts

Roller bracket that mounts refrigerator rollers to the base frame. Replace if your bracket is cracked, bent, broken, or missing to restore stability.

Sealer for refrigerant line insulation.

Secures the refrigerator drain tube to prevent water leaks into the bottom of your fridge or onto the floor. Replace if clip is broken or tube has detached. Verify fit with your model number before ordering.

Seals pantry drawer to maintain proper temperature and prevent air leaks. Replace if torn, cracked, or drawer doesn't close tightly. Verify fit with model.

Rubber grommet that cushions and secures the refrigerator condenser assembly. Replace if cracked, worn, or missing to reduce vibration and noise.

Secure mounting washer for refrigerator assembly. Replaces damaged, missing, or worn washers in various installation points throughout your unit.

Size: 3/16 inch.

Size: 5/16 inch.

Size: 3/8 inch.

Size: 3/4 inch.

Replacement mounting screw for refrigerators, ranges, and other appliances. Replaces lost, stripped, or damaged screws during repairs or maintenance.

This is a discharge tube used in the refrigerator's sealed refrigeration system, connecting the compressor output to the condenser. It carries high-pressure refrigerant as part of the cooling cycle. Replace this tube if it shows signs of damage, kinking, or refrigerant leaks that cause the refrigerator to stop cooling properly.

Size: 1/4 lb.

Putty sealer adhesive for refrigerators and freezers. Seals joints, gaps, and connections. Replace when old sealant is cracked, dried out, or missing.

Refrigerator not cooling properly? This 36-inch condenser coil removes heat from your fridge. Common fix for warm temps and overheating compressors.

This right-side retainer glide is a replacement glide that supports and guides the appliance drum for smooth rotation and reduced wear. It helps restore proper drum alignment and reduces scraping or grinding noises during operation. What it does:

• Provides a low-friction surface for the drum to ride on, keeping rotation stable
• Prevents metal-on-metal contact that can cause scraping or grinding sounds
• Helps correct drum wobble or uneven spinning caused by a worn glide
• Protects the drum and housing from accelerated wear

• One right-side retainer glide

• Disconnect power (and gas, if applicable) before beginning any repair
• Access generally requires removing the front panel or drum assembly; follow the factory service manual for your model
• Inspect mating surfaces and replace any other worn glides or bearings as needed for best results
• Use proper tools and wear safety gear