Kenmore Refrigerator 596.79242011 (59679242011, 596 79242011) Parts

Rubber mounting grommet cushions components and reduces vibration in refrigerators. Replaces worn, cracked, or missing grommets for secure positioning.

This evaporator clip secures the refrigerator evaporator assembly and related components so the cooling system stays aligned and vibration-free. It helps maintain proper airflow and prevents rubbing or loose parts. What it does:

• Holds the evaporator coil/assembly or associated covers in place
• Prevents vibration, noise, and contact between the coil and cabinet parts
• Helps maintain consistent airflow for reliable cooling performance
• Commonly linked to rattling, buzzing, or loose parts around the freezer evaporator

• Disconnect power before servicing the appliance
• Handle evaporator and surrounding fins carefully; they are sharp and fragile
• Verify clip orientation against the OEM diagram before fastening

Secures and seals the water filter in its housing. Replace if cracked, broken, or missing to restore a proper fit after filter changes.

Refrigerator not cooling evenly or running too warm? A worn blower wheel disrupts airflow, causing uneven temperatures and poor cooling performance.

This insulation bag fits inside the refrigerator or freezer door panel to help maintain consistent internal temperatures. It acts as a thermal barrier that prevents warm outside air from affecting the sealed compartment. Replace it if you notice condensation forming on the door interior, inconsistent temperatures, or if the existing insulation is torn, compressed, or missing.

Refrigerator shelf support ladder that secures and stabilizes shelving inside the compartment. Replace if cracked, broken, or missing to restore proper shelf support.

Evaporator shroud cover for refrigerators. Encloses the evaporator coil assembly. Replace if cracked, broken, or missing to restore proper airflow.

Protective housing shroud for refrigerator heater assembly. Replace this cover if cracked, broken, or missing to properly shield heater components.

Plug insert for refrigerators. Installs in cabinet or frame holes. Replace if cracked, broken, missing, or worn to restore clean appearance.

Secures hoses to fittings on water and vent lines to prevent leaks. Replace if loose, cracked, or connection drips. Confirm fit with your model number.

Ice maker not making ice or leaking water? This complete ice maker assembly fixes frozen, jammed, or non-ejecting ice issues. DIY-friendly replacement.

This refrigerator door flipper mullion is the folding center rail that bridges the gap between the doors. It helps complete the door seal and reduces condensation along the center for better temperature retention.

• Bridges the gap between doors to complete the center seal and improve efficiency
• Folds out of the way when a door opens; flips into place as the doors close
• Helps limit moisture/sweating at the middle of the refrigerator
• Replaces a cracked, loose, or broken mullion that causes air leaks, doors popping open, or poor sealing

• Disconnect power before servicing; remove door bins for access
• Remove mounting screws; lift off the assembly and disconnect the harness if equipped
• Transfer any end caps/brackets; ensure spring orientation and proper wire routing during reassembly
• After installation, verify smooth flipping action and a continuous gasket seal down the center