Kenmore Dishwasher 665.743893 (665743893, 665 743893) Parts

Secures water inlet tubing to create a leak-resistant seal. Replace if cracked, stripped, or unable to hold the line securely. Confirm fit with your model.

Replacement 8-32-thread screw used to secure panels, brackets and small components in compatible household appliances. Restores missing or stripped fasteners so panels and parts stay firmly attached during normal use. What it does:

• Secures trim, panels, brackets and control housings to maintain proper assembly.
• Replaces missing or damaged screws that can cause rattling, loose panels or misaligned components.
• Fits locations that require an 8-32 threaded fastener; correct length and head style for your application.
• Helps restore stable, vibration-free operation when worn or stripped fasteners are replaced.

• Disconnect power and water before servicing; wear eye protection and gloves.
• Use the correct screwdriver or driver bit to avoid stripping the screw head.
• Do not overtighten—turn until snug and secure to avoid damaging threads or surrounding parts.
• If the original used a washer or nut, reuse or replace as needed and the screw length and head type match the original.

Dishwasher won't start or stops mid-cycle? A faulty door latch actuator prevents proper door locking. This part restores secure latching function.

This adjustable leveling leg threads into the appliance base to set height and stabilize the cabinet. Replacing a worn or missing leg helps stop rocking and vibration and helps maintain proper alignment for reliable operation.

• Provides adjustable support at one corner of the appliance
• Helps level the unit for correct alignment with floor or cabinetry
• Reduces rocking, vibration, and rattling noises
• Replaces stripped, bent, cracked, or missing leg

• Disconnect power and, if applicable, shut off water before servicing
• Carefully support or brace the appliance to access the base safely
• Start the new leg by hand to avoid cross-threading; adjust height gradually
• Use a level to check side-to-side and front-to-back, then recheck after positioning

Seals the front edge of your dishwasher door to contain water and steam. Replace when you notice leaks or drips at the door opening. Confirm fit.

Color: Black. Size: 12 oz. Acrylic appliance aerosol can spray paint.

Size: 8-18 x 1/2 inch.

Secures ground wire to dishwasher chassis for safe electrical connection. Replace if clip is damaged, missing, or fails to hold wire firmly. Verify fit.

Pronged cup washer secures and cushions components in dishwashers and microwaves. Replace when worn to restore stable fit and reduce wobble.

8-16 thread screw secures panels, brackets, and trim inside refrigerators, dishwashers, and ice makers. Replace if missing, stripped, or damaged.

Fix dishwasher leaks or rattling from the sump area with this sump tab. Secures the sump assembly to the tub, preventing movement and water seepage.

Size: 8-32 x 1/2 inch.

Controls water level and prevents overfilling in your dishwasher. Replace if you notice leaking or overflow issues. Confirm fit using your model number.

13 oz. enamel spray paint in biscuit color for appliances. Restores scratched, chipped, or discolored surfaces on refrigerators, dishwashers, and more.

Internal rear feed cap for dishwasher spray arm system. Replace if damaged, cracked, or water leaks from the rear feed area. Confirm fit with your model.

Fixes water leaking from under the door caused by pressure buildup. This passive vent assembly directs exhaust air out and restores proper venting.