Kenmore Range 665.95824001 (66595824001, 665 95824001) Parts

Replace your range's control knob if it's cracked, broken, or missing. This knob attaches to the control panel and allows you to adjust settings.

This wire harness is an OEM-style electrical assembly that connects and routes power and signals between components, restoring reliable circuit continuity and control communication for affected appliance functions. What it does

• Provides organized routing and secure connections for power and control wires
• Restores electrical continuity to malfunctioning circuits
• Helps resolve symptoms like no power to components, intermittent operation, or unresponsive controls
• Prevents shorting from loose or damaged wires when installed correctly

• Disconnect power (unplug appliance or shut off circuit breaker) before starting any repair
• Compare the harness to the original and route wires along the same path, securing connectors to prevent strain
• Reconnect all plugs fully and avoid pinching wires when closing panels
• Test the appliance after installation; for wiring diagrams and troubleshooting steps

This thermostat senses appliance temperature and helps the control maintain proper cooling. It replaces a failed temperature switch to restore reliable temperature regulation and protect components from overheating. What it does

• Monitors temperature and signals the control board or compressor to turn cooling on or off
• Prevents overheating by opening the circuit when temperatures exceed safe limits
• Commonly replaced when the appliance does not reach or maintain the correct temperature
• Can stop intermittent cooling or continuous-run symptoms when the original thermostat fails

• One thermostat as shown

• For experienced DIYers only; disconnect power before servicing
• Follow manufacturer instructions and verify correct part placement and wiring before restoring power
• Do not modify the part; use proper tools and replacement hardware

This fixed thermostat monitors and helps regulate appliance temperature to maintain safe operation and reliable cooling/heating. It replaces a worn or failed thermostat to restore proper cycling and temperature control. What it does:

• Opens or closes a circuit at a set temperature to control heating or cooling cycles
• Prevents continuous run by signaling the system to stop when the desired temperature is reached
• Commonly used to address symptoms like no temperature control, compressor or heater running nonstop, or failure to reach set temperature
• Works as a safety/control device to reduce risk of overheating when operating correctly

• One fixed thermostat

• Disconnect power before servicing to avoid shock or injury
• Locate and access the thermostat per your model's service instructions (typically mounted near the evaporator, heater, or air path)
• Handle carefully and avoid bending or damaging terminals; verify function with a multimeter if equipped

This replacement transformer steps down household 120VAC, 60Hz power to the low voltage used by the appliance's electronic control. Replacing a failed transformer can restore power to the display/clock and control circuits so cooking functions respond properly. What it does:

• Converts 120VAC line power to low-voltage for the control board/clock and related circuits
• Helps provide stable power to the display and control relays
• Helps resolve: blank or intermittent display, unresponsive controls, oven not starting, or visible heat damage to the original transformer

• One transformer

• Disconnect power at the breaker before servicing; verify no voltage is present
• Note and label all wire positions or take photos before removal; transfer connections one-for-one
• Mount securely and route leads away from sharp edges and hot surfaces
• Inspect wiring and the control board for shorts before restoring power

The microwave cooling fan motor circulates air to prevent the magnetron and other internal components from overheating during operation. Replace if the microwave overheats, makes unusual noises, displays error messages, or shuts down unexpectedly during use.

Made specifically for oven bottoms, this foil helps catch spills in your oven. Perfect for BBQ grills as well.

Color: Biscuit. Size: 1 qt. can uncut. Enamel paint.