Kenmore Cooktop 790.30503601 (79030503601, 790 30503601) Parts

I replaced the ball and socket connection for the drum. After doing so, I realized that the belt had been stretched and the tension pulley was not putting enough tension on the belt to turn the drum. After ordering a new belt, extra screw that was lost while disassembling the dryer, and some high temperature lubricant for the drum ball and socket the dryer now runs as well as it did when it was new. Read more

My wife changed out the burners in about 5 minutes or less, no tools needed Read more

Replaced the burners and installed the right lp conversion kit. All problems solved. The electric igniters work like a charm, I have nice flames and all bright blue. No more messy clean ups after cooking. Read more

Bought new burner tops for all four burners. Lights great now with nice blue flames and no yellow. Read more

We bought a stove off Craigslist and didn't realize it was LP Gas until we got it home and my husband was hooking it up and the burners wouldn't light all the way around. My husband has been out of the gas company for over 10 years now and was a little rusty on what was happening. I jumped online and when I read that the possibility was because LP Gas, my husband said..."thats it." So we jumped online... on a Sunday and actually got a real person to chat with at AppliancePartsPros who told... Read more

I thought this would be a simple remove and replace, boy was I wrong. This repair became more complicated then it should have been. The screws holding the skirt were frozen and broke when trying to remove. Had to end up cutting the skirt using a dremel and a cutting blade. Was able to remove one of the screws using a pinning plier. The other one I had to bore it out using a drill bit. Once that was done the rest was a breeze, discarded bad seal, clean the surface, install the new seal and... Read more

This should be an easy 5 minute three screws out and three screws back in job....but on older stuff it's never easy is it? The screws that hold the skirt on my burner were, like the skirt, rusted solid and despite soaking with PB-1 Blaster they just broke off when I tried to remove them. You can't effectively drill out the remains of the broken screws either (well I couldn't) because the part they screw into is a soft alloy and the screws are hard so the bit wanders off center and if the hole... Read more

They work ok now. Thank you I wii be back?... Read more