Kenmore Range 790.36673400 (79036673400, 790 36673400) Parts

I bought replacement hinges and installed them myself. The hardest part of the job was the first part: to remove the oven door you have to lock the old hinges with small brackets, and one side did not want to lock--I had to use a hammer. The door was heavier than it looks, but the only challenge after that was the fact that the edges of the door parts were sharp. I probably should have worn gloves when handling them. You have to take the door apart to insert the new hinges, but it's just... Read more

It was easy to replace the old clock/timer control board with the new one. I followed these steps: 1. Remove the four control knobs. 2. Remove the four large plastic nuts under the control knobs. This holds down the entire faceplate. 3. Remove the four screws which secure the clock/timer control board and display. 4. Lift up the control board, and remove the multi-pin connector (needed to use a flathead screwdriver to pry open connector tabs). 5. Replace old control board with new control... Read more

After replacing the burner twice and verifying the fuel holes and orifice was not blocked, we fixed the problem by replacing the wiring harness P/N: AP3965774. That and making sure the burner was tightly screwed into the range base to ensure the correct spark gap. Read more

Ordered a new clock/timer control. This was very easy to install the real trick was removing about 8 wires and 4 plug in connectors from the board and then reinstalling them back in the same location as the were before. I took a photo of the board with my IPhone before taking all the wires off, this made it very easy to reinstall the wires on the same terminals as before. There are 2 additional connectors on the board that a flat ribbon cable from the touch button panel attaches to. Do not just... Read more

Ordered new hinges and installed following the instructions on your video. Very easy repair thanks to your video. Thanks Read more

I ordered from the# on the oven. Three weeks went by, tried to call, and got a machine. So I called appliance parts pros and had parts in two days/ Read more