Kenmore Range 790.78889902 (79078889902, 790 78889902) Parts

This trim is a decorative finish piece for select ranges and wall ovens. It covers gaps and raw edges for a clean look and helps keep adjacent panels properly seated when the original becomes cracked, bent, or missing.

• Provides a finished appearance by covering exposed edges or gaps
• Helps maintain alignment of nearby panels or glass
• Replace if cracked, warped, missing, or no longer seats securely
• Common symptoms include loose/rattling panels and exposed or sharp edges

• Disconnect power; for gas models, also shut off the gas supply
• Wear gloves—edges can be sharp
• Remove old trim and transfer/reuse original screws or clips
• Align the new trim and secure with existing fasteners; confirm proper fit before reassembly

Burner tube for gas ranges. Connects gas valve to burner assembly. Replace if cracked, corroded, or leaking to restore proper gas flow to cooktop burners.

Protective cover that shields the range door hinge assembly from debris and damage. Replace if cracked, broken, or missing to restore a clean finished look.

This metal rack fits inside the warming drawer beneath the oven, providing a flat surface to hold plates, dishes, or cooked food at a warm serving temperature. It slides in and out of the drawer on built-in guides. Replace it if the rack is bent, warped, rusted, or missing, which can prevent proper food placement and even heat distribution in the warming drawer.

Decorative trim kit that restores the finished look of your range door. Replaces cracked, chipped, or missing trim pieces and covers exposed door edges.

Protective shield that covers internal components on your gas range. Replace if cracked, broken, or missing to restore protection from debris and moisture.

Insulates the oven cavity to reduce heat transfer and improve energy efficiency. Replace if damaged, compressed, or missing to restore proper insulation.

This is the center surface burner orifice holder and tube assembly for a gas range. It directs gas flow from the valve to the burner head and meters the correct amount of fuel for proper flame output. Replace this assembly if the center burner produces an uneven flame, won't ignite consistently, or if the orifice is clogged or damaged.

Mounting bracket that secures the gas pressure regulator to your range frame. Replace if bent, broken, or missing to properly support the regulator assembly.

Guide pin for gas ranges. Secures and aligns oven or burner components. Replace if broken, missing, or worn to restore proper part positioning.

This is the inner liner panel of the oven door, typically made of porcelain-coated steel or similar heat-resistant material. It sits behind the door glass and helps insulate the oven cavity, reflecting heat back inside for efficient cooking. Replace this liner if it is cracked, chipped, rusted, or if you notice heat escaping from the oven door during use.

This is a control knob designed to fit over the top burner valve stem on a gas range cooktop. It allows you to turn the surface burner on and off and adjust the flame height. Replace this knob if it is cracked, worn, or the indicator markings have faded, or if the knob spins freely without engaging the valve.

Fix a burner that won't light, won't adjust heat levels, or stays on constantly with this range top burner valve. Moderate DIY repair in 30-45 minutes.

Replacement screw for range assembly and mounting. Needed when original screws are stripped, missing, or damaged during repairs or appliance maintenance.

This is a heating element designed for the warming drawer of a range. It provides low, consistent heat to keep food warm after cooking. Replace this element if your warming drawer no longer heats, heats unevenly, or has visible damage such as cracks or burn marks.