Kenmore Range 790.79523604 (79079523604, 790 79523604) Parts

This should be an easy 5 minute three screws out and three screws back in job....but on older stuff it's never easy is it? The screws that hold the skirt on my burner were, like the skirt, rusted solid and despite soaking with PB-1 Blaster they just broke off when I tried to remove them. You can't effectively drill out the remains of the broken screws either (well I couldn't) because the part they screw into is a soft alloy and the screws are hard so the bit wanders off center and if the hole... Read more

Replaced the selector knob potentiometer: 1) Pull off selector knob 2) Remove 3 screws holding the knob trim piece and pull it off 3) Remove the nut on knob potentiometer 4) Open the door and remove 3 screws on the bottom of the control panel 5) Lift control panel then pull out (may need to wiggle a bit to dislodge the clips in the top corners) 6) (Optional) Disconnect the necessary wire bundles from the control board on the back of control panel to allow complete removal of the control panel.... Read more