Kenmore Range 790.93771100 (79093771100, 790 93771100) Parts

Replacement wire shelf that supports cookware inside the oven cavity. Install when your original rack is bent, rusted, warped, or missing.

Decorative medallion trim piece that restores your range's finished appearance. Replaces scratched, faded, or missing trim to maintain original styling.

Body-side spacer for gas range door or lid hardware. Installs on cabinet side to set correct stand-off and alignment. Replace if cracked or missing.

Range indicator light lens kit with red and clear lenses. Replace when cracked, discolored, or missing. Fits control panel burner indicators. Verify fit.

Rubber bumper that cushions the range door or drawer when closing. Replace if cracked, worn, or missing to prevent rattling and protect surfaces.

Flat cooktop surface that mounts over your range's burner elements. Replace if cracked, chipped, deeply scratched, or worn from years of cooking.

Replacement housing cover for your range. Installs on the exterior or internal housing assembly. Order a new cover if yours is cracked, broken, or missing.

Replace your range's warmer control knob if the original is cracked, broken, worn, or missing. This knob attaches to the warmer zone control shaft.

Heat reflective foil strip for range oven doors. Insulates handle and sides from heat. Replace when damaged or during glass replacement. Confirm fit.

This replacement door gasket creates a tight seal around the refrigerator or freezer door to help maintain consistent temperatures and reduce energy loss. Designed to match the OEM shape and restore proper sealing. What it does:

• Seals the door edge to help keep cold air in and warm air out
• Helps prevent frost buildup and reduces compressor run time when sealing properly
• Can stop drafts and eliminate wet or warm spots on door edges
• Restores the door's original fit when worn, torn, or deformed

• One door gasket

• Designed for a direct replacement; inspect mounting channel and retainer before installing
• Warm the gasket slightly for easier fitting if needed; avoid overheating
• Clean the door frame and remove old adhesive or debris for a proper seal

Size: 8-18ab x 0.5 inch.

Replacement auto latch rod for your range door mechanism. This metal rod connects the latch assembly. Order a new one if yours is bent, broken, or missing.

Rod end cover for gas ranges. Protects and conceals the rod end mechanism. Replace if cracked, broken, or missing to restore proper appearance and coverage.

Hex head screw for securing range components. Replace if stripped, rusted, or missing to ensure proper assembly and secure mounting of panels or parts.