Kenmore Refrigerator 795.75559400 (79575559400, 795 75559400) Parts

This center hinge assembly supports and pivots the middle door section to keep doors aligned and operating smoothly. Replace a worn or damaged center hinge to restore proper door movement and help maintain a tight seal. What it does:

• Provides the pivot point and structural support for the center door section to open and close smoothly
• Helps maintain door alignment to prevent rubbing, scraping, or uneven gaps
• Reduces door sag that can interfere with sealing and cooling efficiency
• Prevents binding or sticking during door operation

• One center hinge assembly

• Disconnect power to the appliance before starting any repair
• Doors are heavy—have a second person assist to support doors while removing or installing the hinge
• Remove any trim or covers to access hinge screws; align doors fully before tightening fasteners
• Use manufacturer-recommended torque; do not overtighten screws or force parts into place

This is a rear end cap that attaches to the end of the refrigerator door handle. It provides a finished appearance and secures the handle in place. Replace this cap if it is cracked, broken, or missing, which can cause the handle to feel loose or look incomplete.

Replacement mounting screw for refrigerator panels, trim, and components. Secures loose or missing fasteners to reduce vibration and keep parts in place.

This is a black plastic end cap that attaches to the refrigerator door handle to provide a finished appearance and help secure the handle in place. It snaps onto the end of the handle assembly. Replace this cap if it is cracked, broken, or missing, which can cause the handle to feel loose or detract from the refrigerator's appearance.

Lower cover assembly for bottom-mount refrigerators. Replaces cracked, broken, or missing lower covers. Installs at the base of the refrigerator.

Replacement mounting screw for refrigerator assembly. Secures panels, brackets, or components. Needed when original screw is stripped, lost, or damaged.

This drum support roller helps the dryer drum rotate smoothly and quietly by reducing friction between the drum and cabinet. Replacing a worn roller restores stable drum movement and cuts down on noise and wear. What it does:

• Supports the dryer drum so it turns evenly during cycles
• Reduces squealing, grinding, or rumbling caused by worn bearings or flat spots
• Helps prevent drum wobble and uneven clothing tumbling
• Low-friction bearing surface prolongs drum and belt life

• Power off and unplug the appliance before starting any repair
• Access usually requires removing the dryer front or rear panel and drum—follow your model's service instructions
• Inspect the shaft, hanger, and adjacent rollers or glides; replace any other worn parts to avoid premature failure

Rubber damper bumper for refrigerators. Installs to reduce vibration and noise. Replace if worn, cracked, or missing to restore cushioning support.

Lower door hinge assembly for bottom-mount refrigerators. Mounts the lower refrigerator door to the cabinet. Replace if cracked, broken, or worn.

The Refrigerator Light Lens is an OEM part for LG refrigerators. It serves as a protective cover for the interior lighting system, shielding the light bulbs or LEDs from dust, moisture, and accidental impacts. The lens measures about 14 inches wide by 5-1/2 inches deep.

Symptoms of a faulty light lens:

• Dim or flickering interior lights
• Light leaks or scattered light distribution
• Cracked, broken, or missing light lens
• Water or moisture buildup inside the light housing

Causes of a bad light lens can include physical damage from impact, exposure to extreme temperatures or moisture, or general wear and tear over time.

This OEM LG part is also compatible with Sears/Kenmore refrigerator models.