Kenmore Refrigerator 795.79772902 (79579772902, 795 79772902) Parts

A replacement cover motor that powers the refrigerator's dispenser cover, allowing the door to open and close so you can access ice and water. Replaces a worn or failed motor to restore normal dispenser cover operation. What it does:

• Drives the dispenser cover mechanism so the cover opens when dispensing and closes when idle
• Helps keep the dispenser sealed to reduce drafts and prevent pests or debris from entering
• Stops or fails to move when worn, causing a stuck, slow, or noisy dispenser cover
• Works with the dispenser linkage and gears to coordinate cover motion with user controls

• One cover motor

• Disconnect power to the appliance before beginning any repair
• Remove dispenser trim and access panel per your model's service instructions to reach the motor
• Handle gears and linkage carefully; ensure proper alignment during reassembly and test cover operation before finishing

This is a rear end cap that attaches to the refrigerator door handle, providing a finished appearance at the handle's end. It snaps or fastens onto the handle assembly to secure it in place. Replace this cap if it is cracked, broken, or missing, which can cause the handle to feel loose or look incomplete.

Refrigerator won't cool or compressor won't start? This overload protector shields the compressor from electrical surges. Simple install in 15 minutes.

Freezer door handle for bottom-mount refrigerators. Replaces broken, cracked, or loose handles. Mounts to the freezer drawer for smooth opening.

Wire harness assembly for bottom-mount refrigerators. Connects electrical components throughout the unit. Replace if wires are frayed, damaged, or corroded.

Replace your refrigerator's light cover lens to restore proper illumination and protect the bulb. Fits if your dome light lens is cracked or yellowed.

Replacement ice cube tray for your refrigerator freezer. Holds water in molded cavities to form ice cubes. Replace if cracked, broken, or missing.

Replacement mounting bolt for refrigerator components and assemblies. Needed when original fastener is missing, stripped, or damaged during service work.

Replace your refrigerator's broken, cracked, or missing door handle. This exterior handle installs on the door for easy opening and closing.

This is the main power control board assembly that manages key appliance functions and power distribution, restoring control logic and electronic operation when the original PCB fails. Designed as a direct-replacement PCB assembly. What it does:

• Controls appliance power sequencing and electronic functions for start, cycle selection and timing
• Interfaces with user controls, sensors and motors to coordinate operation
• Can stop normal operation or cause error codes, intermittent power, or failure to start when faulty
• Restores reliable electronic control when installed correctly and matched to the appliance

• Disconnect power at the breaker or unplug the appliance before service
• Handle the PCB by the edges and avoid touching components to prevent ESD damage
• Verify harness connectors fully seat and routing matches the original; secure mounting screws