Lg Washer Dryer Combo 31522 Parts

Small metal washer used in washer internal mounting assemblies. Provides proper spacing between components and secures fasteners. Replace if worn or missing.

Secures rubber hoses to fittings with constant spring tension to prevent leaks. Replace when rusted or weakened to maintain a tight seal. Confirm fit.

Replacement mounting bracket holder that secures internal washer components. Needed when your original bracket is cracked, broken, or missing.

Tapping screw secures washer panels, brackets, and trim in place. Replace stripped, rusted, or missing screws to restore proper fit and stability.

Fix exposed fasteners or openings on your washer dispenser with this protective cover cap. Keeps dirt and moisture out while restoring a clean finish.

This knob assembly replaces a worn or broken control knob so you can reliably set and adjust appliance settings. It restores a secure, easy-to-turn interface for the appliance's control shaft. What it does:

• Fits onto the control shaft to allow manual selection of settings and temperatures.
• Replaces cracked, stripped, or loose knobs that no longer grip the control shaft.
• Helps resolve issues where the control won't turn smoothly or slips while changing settings.
• Restores tactile feedback for accurate user control.

• Disconnect power to the appliance before removing or installing the knob.
• Pull the old knob straight off the control shaft.
• Align the knob's internal splines with the control shaft and push until fully seated.
• If knob does not seat or control still slips, inspect shaft splines and replace damaged components as needed.

Secures internal components to the washer frame. Replace if your bracket is cracked, rusted, broken, or missing to restore stable support and alignment.

This is a small rubber pad that sits beneath the leveling leg of a washing machine. It helps absorb vibration, reduce noise, and prevent the machine from sliding on the floor during operation. Replace this pad if it is cracked, worn, or missing, which can cause excessive vibration, walking, or noise during the spin cycle.

Secures internal washer components in proper alignment. Replace this mounting bracket if cracked, rusted, broken, or missing to restore stability.

Connects the washer's inner drum to the drive assembly. Replace if cracked, damaged, or worn to restore drum stability and eliminate wobbling or noise.

Replacement mounting bracket that secures internal washer components in position. Needed when original bracket is cracked, broken, or loose causing parts to shift.

Replace your washer's control panel housing case if cracked, broken, or damaged. This protective cover secures and shields internal components.

Top cover panel for top-load washers. Replace if rusted, cracked, or damaged. Covers main tub area and holds components. Verify fit by model number.

This replacement holder secures a small appliance component in place to restore proper alignment and reduce vibration. It's a direct-fit bracket designed to hold components steady and prevent movement that can cause noise or malfunction. What it does:

• Keeps the associated component firmly mounted to its chassis or support
• Prevents rattling, misalignment, or intermittent contact caused by a damaged or missing holder
• Helps maintain proper operation of the component it supports
• Common symptoms: visible crack or break in the holder, loose or shifting component, or new noise from the area

• One replacement holder as shown

• Disconnect power and/or water supply before beginning any repair
• Inspect surrounding parts for damage before installing the new holder
• Basic hand tools are typically required; avoid overtightening fasteners

Protective cover for your washer. Replaces damaged, cracked, or missing covers. Installs to shield internal components from debris and moisture.