Lg Range 76037 Parts

This is a circular wire harness holder that secures and organizes internal wiring within the range. It clips onto the frame or mounting points to keep wires routed properly and away from heat sources. Replace this part if it is broken or missing, which can cause loose wiring or potential contact with hot surfaces.

This Knob Assembly replaces a worn or broken control knob so you can select cycles and settings accurately. It restores a positive grip and smooth rotation for reliable control of the appliance. What it does:

• Allows selection of functions, cycles, or temperature settings on the control panel
• Replaces stripped, cracked, or loose knobs that no longer turn or click into position
• Restores tactile feedback and improves control accuracy
• Helps eliminate slipping or intermittent contact between the user and the control shaft

• One Knob Assembly as shown

• Disconnect power before beginning any repair to avoid shock or injury
• Pull off the old knob by hand; align and press the new knob onto the control shaft until it seats
• If the knob is secured with a set screw, loosen/tighten with the proper screwdriver — do not overtighten

This is a VFD (vacuum fluorescent display) module that mounts behind the range's control panel and shows time, temperature, error codes, and cycle status. It communicates with the main electronic control board to relay information to the user. Replace this display board if the screen is blank, dim, flickering, showing incomplete characters, or displaying incorrect information even after a power reset.

Replace your worn range oven door gasket to restore proper heat sealing and improve cooking efficiency. Verify fit with your model number before ordering.

Base plate for electric and gas ranges. Provides structural support at the bottom of the range. Replace if cracked, warped, or damaged from wear.

The range packing seal creates an airtight barrier around oven doors or other range components to maintain proper cooking temperatures and prevent heat loss. Positioned around door edges or component joints, it needs replacement if heat escapes, cooking becomes uneven, or the seal appears cracked or compressed.

Replacement mounting screw for electric and gas ranges. Secures components and panels. Needed when original screw is stripped, missing, or damaged.

This is a wire holder clip used inside a microwave to secure and route internal wiring. It keeps wires organized and safely positioned away from heat sources and moving components. Replace this holder if it is broken or missing, which can allow wires to hang loose and potentially contact hot surfaces or interfere with other parts.

Replace a damaged or corroded wire harness in your range. This single-connection harness restores proper electrical connections when original wiring is frayed, melted, or broken.

Wire harness for gas ranges. Connects electrical components inside your range. Replace if wires are damaged, frayed, burned, or connections are loose.

Secures the door hinge to the range cabinet for proper alignment. Replace this bracket if it's cracked, bent, or missing to restore stable door support.

Mounting bracket for gas ranges. Secures components in place during operation. Replace if bracket is bent, cracked, broken, or missing hardware holes.

Replace a gas range burner when flames are uneven, won't ignite, or produce yellow flames. Direct swap installation takes 10-15 minutes with basic tools.

Burner nozzle holder for gas ranges. Secures the gas nozzle in the burner assembly. Replace if cracked, broken, or missing to ensure proper alignment.

Replace a burner tube if flames are uneven, yellow, or won't ignite properly on your gas range. Moderately easy repair restores proper gas flow.