Lg Dryer DLEX2550S Parts

Inner door frame for dryers. Secures the door glass and outer panel assembly. Replace if cracked, warped, or broken to restore door structure and seal.

Replacement outer door frame that surrounds the dryer's front door. Restores secure fit and finished look when original is cracked, dented, or worn.

This dryer guide cover cap installs on the drum or guide assembly. Replace if your original cover is cracked, broken, missing, or worn from regular use.

Safety cover cap for dryers and laundry centers. Protects internal components and covers exposed areas. Replace if cracked, broken, or missing.

Sound dampening insulation that reduces dryer noise and vibration. Replace if worn, torn, or missing to restore quiet operation and cushioning.

This is a flexible hose that connects the condensate drain pump to the water drainage system in a condensing dryer. It carries collected moisture from the pump to the drain outlet or reservoir. Replace this hose if you notice water leaking beneath or behind the dryer, or if the pump is running but water is not being properly drained.

This is the appliance's main electronic control board (PCB assembly). It manages power distribution and operating logic for key functions. Replacing a failed board can restore normal operation when the unit is dead, unresponsive, or behaving erratically. What it does

• Routes power and coordinates major loads (motors, heaters, fans, valves) based on sensor feedback and user settings
• Controls timing and modes for normal operation
• Monitors safety circuits and error conditions
• Common symptoms of a failed board: no power/won't start, blank or dead display, won't complete cycles, intermittent shutdown or clicking, erratic operation, recurring error codes

What's included

• One main control board (PCB) assembly

Install notes

• Disconnect power before servicing; allow capacitors to discharge fully
• Use ESD protection and handle the board by the edges only
• Photograph connectors; move any jumpers, covers, or brackets from the old board to the new one as required
• Inspect wiring and connected components for shorts, heat damage, or moisture before powering up the new board