Lg Dryer DLEX5680WE Parts

Horizontal bar connector for dryer assembly. Replace if broken, cracked, or missing to restore proper structural connection between components.

This generator assembly senses motor rotation and provides the control board with speed/position feedback so the washer can time cycles and spin properly. It replaces a worn or damaged sensor assembly to restore reliable cycle control. What it does:

• Detects motor rotation and sends position/speed signals to the washer control board
• Helps the machine maintain correct spin speeds and cycle timing
• Can address symptoms like no spin, erratic spinning, or motor-related error codes when the generator fails
• Works with the motor/mounting components to ensure accurate feedback for drive operations

• One generator assembly

• Disconnect power before servicing to avoid shock or injury
• Requires basic tools and access to the washer's motor area; handle connectors and sensor surfaces carefully
• Reuse or replace any mounting hardware only if specified by the manufacturer

Secures the door hinge assembly to the cabinet for proper door support and alignment. Replace when the hinge area is cracked, worn, or damaged.

This is the rear tub drum for the washer's drum assembly; it supports the inner drum and helps keep loads balanced so the washer can tumble and spin properly. Use this part to restore stable drum rotation and reduce rubbing or banging noises. What it does:

• Supports the inner wash basket and maintains proper alignment during spin cycles
• Keeps the drum centered to prevent rubbing against the cabinet or seal
• Helps reduce loud banging, wobbling or excessive vibration during operation
• Works with the tub seals, bearings and suspension to maintain smooth rotation

• One rear tub drum

• Disconnect power and water before beginning any repair
• This is a major drum component; expect to remove the outer cabinet and other assemblies to access it
• Support the inner drum while separating components; bearings, seal and hardware may need inspection or transfer

Replace your dryer drum assembly if clothes aren't tumbling, you hear scraping noises, or the drum won't rotate. Moderate DIY repair in 1-2 hours.

Fix intermittent dryer operation or complete failure with this wire connector harness. Restores electrical connections between components for reliable performance.

Small trim cap that snaps over exposed screws and mounting holes on your dryer. Replace if cracked, broken, or missing to restore a clean finish.

Safety cover cap for dryers and laundry centers. Protects internal components and covers exposed areas. Replace if cracked, broken, or missing.

Covers and protects the drum light bulb in your dryer. Replace if the lens is cracked, broken, discolored, or missing to restore proper light coverage.

Sound dampening insulation that reduces dryer noise and vibration. Replace if worn, torn, or missing to restore quiet operation and cushioning.

Replace your dryer's worn, cracked, or broken door handle. Restores secure grip for opening and closing. Direct fit for original mounting points.

This is a flexible hose that connects the condensate drain pump to the water drainage system in a condensing dryer. It carries collected moisture from the pump to the drain outlet or reservoir. Replace this hose if you notice water leaking beneath or behind the dryer, or if the pump is running but water is not being properly drained.

This replacement locker handle restores a secure grip and reliable latch operation on the appliance door or access panel. It replaces a cracked, loose, or missing handle so the door opens and closes smoothly. What it does:

• Provides a firm handhold for opening and closing the door or access panel
• Secures the door latch area to help maintain proper closure
• Replaces broken, cracked, or worn handles that are hard to grip
• Helps reduce rattling or loose-feeling door operation

• One locker handle

• Disconnect power to the appliance before beginning any repair
• Remove any trim or access panels as needed; use basic hand tools
• Handle may attach with clips or screws — keep hardware organized for reassembly
• Test door operation after installation; if fit feels incorrect, check part number and orientation