Lg Washer F14A8FD Parts

Cast metal spider that secures the wash drum to the drive shaft. Replace when cracked, corroded, or broken to restore proper drum support and alignment.

Fix washer not filling or slow fill issues. This water inlet hose connects your home supply to the washer inlet valve. Simple DIY install restores flow.

Connector hose for washers and washer-dryer combos. Links water supply lines or internal components. Replace if cracked, leaking, or disconnected.

Secures the door hinge assembly to the washer frame. Replace if the bracket is cracked, bent, or fell off during hinge replacement or maintenance work.

Protector cover for washer dryer combo units. Installs to shield internal components from damage. Replace if cracked, broken, or missing for proper protection.

This rear cover is the exterior cabinet panel that protects the appliance's internal components and helps maintain proper airflow. It restores a finished back surface and prevents debris or pets from contacting working parts. What it does:

• Protects internal parts from dust, spills and physical damage
• Helps direct airflow and maintain proper ventilation paths
• Replaces cracked, warped or missing back panel that can cause rattles or expose components
• Reduces risk of foreign objects entering the appliance and interfering with operation

• One rear cover panel

• Disconnect power and any fuel lines before beginning repair
• Remove existing access panels and fasteners; retain hardware if reusing
• Handle edges carefully—metal panels can be sharp

This balance weight stabilizes the washer drum to reduce vibration and keep the washer steady during spin cycles. Replacing a worn or damaged weight restores smoother operation and reduces shaking and noise. What it does:

• Adds mass to the washer frame/drum assembly so the tub stays balanced during spin
• Helps prevent excessive vibration, banging, and movement during high-speed spins
• Reduces noise caused by an unbalanced load or damaged weight
• Supports proper drum alignment to avoid premature wear on bearings and suspension parts

• One balance weight

• Always unplug the washer before starting any repair to avoid electrical shock
• Support the drum/tub when removing or installing the weight to prevent component damage
• Reuse or replace any mounting hardware only if explicitly specified by the manufacturer
• If vibration persists after replacement, inspect suspension, shock absorbers, and mounting points