Lg Washer F14A8FD Parts

Inlet hose for washers. Connects water supply to machine. Replace if cracked, leaking, kinked, or worn. Essential for proper water flow to drum.

Holder assembly for washer and washer-dryer combo units. Secures internal components in position. Replace if cracked, broken, or missing to restore stability.

This door lock switch assembly secures the washer door and tells the control when the door is locked so cycles can start and run safely. Replacing a worn lock switch restores normal door latching and cycle operation. What it does:

• Electrically detects and the door is locked so the washer will begin or continue a cycle.
• Engages the latch mechanism to hold the door closed during wash and spin.
• Commonly used when the washer won't start, the door won't lock, or the control won't accept a start command.
• Helps prevent the door from opening mid-cycle, protecting clothes and preventing leaks.

• Disconnect power before servicing to avoid shock or damage.
• Access typically requires removing the washer's front or top panel; keep fasteners organized.
• Handle the assembly and wiring harness carefully to avoid connector damage.
• Test operation after installation and reassemble panels securely.

Protective cover cap that conceals screws or fasteners on your appliance. Replace if the original cap is cracked, broken, missing, or discolored.

This rotor position sensor (Hall sensor) tracks the direct-drive motor's rotor position and speed so the control can commutate the washer motor accurately. Replacing a failed sensor can restore proper wash/agitate and spin performance. What it does:

• Detects rotor position and speed from the stator assembly
• Sends timing feedback to the control for correct motor start, direction, and speed
• Supports smooth agitation and spin ramp-up/ramp-down
• Failure may cause: no spin or agitation, cycle stalling/pausing, or an LE motor error code

• 1 rotor position sensor assembly

• Unplug the washer and shut off water; wear protective gloves
• Access the motor at the rear of the tub; remove the back panel if needed
• Remove the rotor and stator; support the stator to protect wiring, then unclip/unscrew and replace the sensor
• Align the sensor correctly and seat the connector fully before reassembly and testing

Air chamber dome for washer pressure systems. Installs on the tub assembly to regulate water level sensing. Replace if cracked, damaged, or missing.

Secures internal washer components and maintains proper alignment. Replace when brackets are worn, broken, or causing rattling. Confirm fit with your model number.

Leveling leg assembly for washers and laundry centers. Installs at the base to support and level the unit. Replace if cracked, broken, or missing.

Leaking washer water line? This connector hose seals your appliance water line to internal plumbing, stopping leaks and restoring water flow. Simple fix.

Cast metal spider that secures the wash drum to the drive shaft. Replace when cracked, corroded, or broken to restore proper drum support and alignment.