Lg Wall Oven LMS9071SW Parts

A Tap-Tite binding-head screw used to fasten appliance panels and components where a self-tapping metal thread is required. Replaces missing or damaged fasteners to restore secure assembly and reduce vibration or rattling. What it does:

• Creates its own mating thread in thin sheet metal for a secure hold without a nut.
• Holds panels, brackets, and trim in place to prevent looseness or movement.
• Commonly used where stripped, missing, or broken screws cause rattling, misalignment, or parts that won't stay attached.
• Compatible with standard screwdrivers or nut drivers sized to the binding-head.

• Disconnect power and unplug the appliance before working on it.
• Use the correct driver bit to avoid cam-out or head damage.
• Start straight and apply steady pressure; avoid overtightening to prevent stripping the formed threads.
• If the original hole is badly damaged, assess for repair or use of a larger fastener as needed.

Microwave won't start or door won't stay closed? This door latch secures the door so your microwave operates properly. Simple DIY fix in minutes.

Microwave overheating or shutting off unexpectedly? This thermostat regulates temperature to prevent damage. A straightforward fix for most DIYers.

Microwave won't heat but runs normally? This magnetron generates microwave energy to cook food. Requires high-voltage safety knowledge to replace.

Replace worn, cracked, or missing door seal tape on your microwave. This adhesive strip installs around the door frame to maintain proper sealing.

Replace a microwave fan motor when your microwave overheats, shuts off unexpectedly, or the cooling fan stops running. Direct-fit replacement part.

This out case (U-bending) is the molded housing piece that secures and routes the U-shaped tubing or conduit on the appliance, helping maintain proper alignment and protection from wear. It restores correct routing and support for affected assemblies. What it does:

• Holds and guides the U-bend tubing/conduit to prevent kinks and rubbing
• Protects tubing from vibration and contact damage during operation
• Helps maintain proper routing for consistent fluid/air flow
• Common symptom: visible tubing wear, rubbing, or misalignment near the U-bend
• Common symptom: noise or vibration traced to loose or displaced tubing

• One out case (U-bending) as shown

• Power off and disconnect the appliance before servicing to avoid electrical shock
• Inspect adjacent tubing and fasteners; replace any damaged clips or seals as needed
• Tighten fasteners to OEM guidance and verify tubing is correctly seated in the new case