Lg Range LSSG301 Parts

Fix range display not working, oven not heating, or control panel errors with this power control board assembly. Moderate DIY repair for ranges.

This is a replacement screw used to secure appliance components and panels. It restores proper fastening where a stripped, missing, or damaged screw causes loose parts or rattling. What it does:

• Fastens panels, trim, or internal components to maintain structural fit
• Helps stop vibration-related noise from loose assemblies
• Replaces missing or corroded screws that prevent proper closures
• Restores secure mounting after repairs or disassembly

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug—do not over-torque to prevent thread damage
• Keep small parts away from children and pets
• Disconnect power or water before accessing internal parts

Fix intermittent power issues or control failures with this range main wiring harness. Connects electrical components for proper signal communication.

Burner cap for gas ranges. Fits over the burner assembly to protect from debris and damage. Replace if cracked, chipped, or missing for proper operation.

Replacement screw for electric and gas ranges. Secures internal components and panels. Needed when original is stripped, missing, or damaged during repair.

Accessory assembly for electric and gas ranges and wall ovens. Replaces damaged, broken, or missing accessory components. Restores proper fit and function.

Fix a burner that won't light or heat unevenly with this gas range burner assembly. Common repair for weak or inconsistent flames on cooktop surfaces.

Replace a burner assembly when flames are uneven, won't ignite, or produce yellow flames. This repair typically takes 15-30 minutes with basic tools.

Replace a gas range burner assembly when flames are uneven, burner won't ignite, or produces weak heat. Moderate DIY repair in 30-45 minutes.

Wire harness for gas ranges. Connects electrical components inside your range. Replace if wires are frayed, damaged, or connections are loose or broken.

Replace your range's wire harness if the existing wiring is damaged, frayed, or showing signs of wear. Connects electrical components inside your range.

Fix range control panel display issues or power failures with this DC power jack. Restores electrical connection to control board. Moderate DIY repair.

This main control board manages the appliance's power distribution and core control functions so the unit can respond to user inputs and run cycles reliably. Replace a damaged board to restore normal control and operation. What it does

• Regulates and distributes power to the appliance's motors, sensors, and control circuits.
• Processes user inputs and runs the control logic that starts and stops cycles.
• Common symptoms: appliance won't power on, controls unresponsive, intermittent operation, or error codes related to control/communication.
• Replacement often resolves erratic behavior caused by failed components on the board.

• One main control board assembly.

• Disconnect power (unplug or switch off circuit breaker) before starting any work.
• Handle the board by its edges and avoid touching solder joints; use anti-static precautions when possible.
• Verify connector orientation and seating before reapplying power; transfer any required brackets or standoffs from the old board if applicable.

Secures and supports your range oven door hinge for proper alignment and smooth operation. Replace if bracket is cracked, bent, or damaged to restore door fit.