Lg Wall Oven LSWD309 Parts

This single wiring harness connects electrical components to restore power and signal paths in your appliance. It replaces a damaged or worn harness to help appliances operate reliably and safely. What it does:

• Routes power and signal between controls, sensors, and motors
• Replaces frayed, burned, or broken wiring that causes intermittent power or failures
• Helps stop shorts, erratic behavior, or components that won't receive power
• Matches OEM connector ends and wire colors for a direct replacement when the OEM part is specified

• Disconnect power and unplug the appliance before starting any repair
• Compare the harness to the original before installing
• Secure routing to avoid pinching, chafing, or contact with hot surfaces

The Common Nut is an OEM part for LG ranges. It secures the fan blade to the motor shaft. This nut maintains the fan's stability and preventing it from becoming dislodged during use.

Causes of a bad common nut can include loosening over time due to vibration, improper installation, or damage from impact or mishandling.

Symptoms of a bad common nut include:

• Excessive noise or vibration from the fan assembly
• The fan blade becoming loose or detached, causing poor air circulation
• Potential risk of the fan blade becoming a projectile if completely detached

This OEM LG part is also compatible with some Kenmore models.a

Fixes power connection issues or arcing at the terminal block. This socket connects your range power cord to internal wiring. Moderate DIY repair.

Wire harness for gas ranges and wall ovens. Connects electrical components within the appliance. Replace if wires are frayed, damaged, or connections are loose.

Wire harness for ranges and wall ovens. Connects electrical components within the appliance. Replace if wires are damaged, frayed, or connectors are broken.

This hardware washer helps distribute fastener load and maintain proper spacing in your LG appliance. Replacing a missing or worn washer restores secure mounting and alignment, reducing vibration and rattling from loose assemblies.

• Distributes the load of a screw or bolt and protects mating surfaces to maintain alignment
• Helps keep components secure and at the correct spacing
• A damaged or missing washer can lead to loosening, vibration, or rattling during operation
• Ensures correct hardware stack-up during reassembly after service

• Disconnect power and shut off water or gas before servicing
• Note the order and orientation of any washers/spacers; take a reference photo
• Use the correct driver or wrench and tighten snugly—do not overtighten
• Replace companion hardware if corroded, stripped, or damaged

Fixes intermittent power or control issues caused by damaged wiring. This harness restores electrical connections between range components for reliable operation.

Range controls not responding or features intermittent? This wiring harness restores power and signal connections between components for reliable operation.

This is a VFD (vacuum fluorescent display) module that mounts behind the range's control panel and shows time, temperature, error codes, and cycle status. It communicates with the main electronic control board to relay information to the user. Replace this display board if the screen is blank, dim, flickering, showing incomplete characters, or displaying incorrect information even after a power reset.

Wall oven stopped moving or cycling intermittently? This AC synchronous motor assembly restores precise rotation and timing. Moderate DIY repair.

Fix a broken or unresponsive control dial on your wall oven with this circuit board assembly. Restores precise temperature control and oven functions.

Replacement mounting nut for cooktops and ranges. Secures components during installation. Order a new nut if yours is stripped, missing, or damaged.