Lg Wall Oven LSWD309 Parts

Fix a range that won't heat, cycle on, or respond to buttons. This control board assembly interprets inputs and restores reliable oven operation.

Wire harness for gas ranges and wall ovens. Connects electrical components within the appliance. Replace if wires are frayed, damaged, or connections are loose.

This hardware washer helps distribute fastener load and maintain proper spacing in your LG appliance. Replacing a missing or worn washer restores secure mounting and alignment, reducing vibration and rattling from loose assemblies.

• Distributes the load of a screw or bolt and protects mating surfaces to maintain alignment
• Helps keep components secure and at the correct spacing
• A damaged or missing washer can lead to loosening, vibration, or rattling during operation
• Ensures correct hardware stack-up during reassembly after service

• Disconnect power and shut off water or gas before servicing
• Note the order and orientation of any washers/spacers; take a reference photo
• Use the correct driver or wrench and tighten snugly—do not overtighten
• Replace companion hardware if corroded, stripped, or damaged

This is a replacement screw used to secure appliance components and panels. It restores proper fastening where a stripped, missing, or damaged screw causes loose parts or rattling. What it does:

• Fastens panels, trim, or internal components to maintain structural fit
• Helps stop vibration-related noise from loose assemblies
• Replaces missing or corroded screws that prevent proper closures
• Restores secure mounting after repairs or disassembly

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug—do not over-torque to prevent thread damage
• Keep small parts away from children and pets
• Disconnect power or water before accessing internal parts

Fixes intermittent power or control issues caused by damaged wiring. This harness restores electrical connections between range components for reliable operation.

This is a circular wire harness holder that secures and organizes internal wiring within the range. It clips onto the frame or mounting points to keep wires routed properly and away from heat sources. Replace this part if it is broken or missing, which can cause loose wiring or potential contact with hot surfaces.

Range controls not responding or features intermittent? This wiring harness restores power and signal connections between components for reliable operation.

This is a VFD (vacuum fluorescent display) module that mounts behind the range's control panel and shows time, temperature, error codes, and cycle status. It communicates with the main electronic control board to relay information to the user. Replace this display board if the screen is blank, dim, flickering, showing incomplete characters, or displaying incorrect information even after a power reset.

Wall oven stopped moving or cycling intermittently? This AC synchronous motor assembly restores precise rotation and timing. Moderate DIY repair.

Fix a broken or unresponsive control dial on your wall oven with this circuit board assembly. Restores precise temperature control and oven functions.

Replace your worn range oven door gasket to restore proper heat sealing and improve cooking efficiency. Verify fit with your model number before ordering.

Oven not cooling properly or overheating? This fan assembly restores airflow and temperature control. Includes motor and blade for complete repair.

Replace a broken or damaged motor bracket causing loose or misaligned oven fan motor. Straightforward repair that restores proper motor mounting and support.

Mounting bracket for wall ovens. Secures oven to cabinet cutout. Replace if bracket is bent, cracked, or missing to ensure safe oven installation.