Samsung Wall Oven PVM-9215SF2SS Parts

Opened up hinged bottom of microwave and saw that the old motor had come loose from its secure position. I decided to replace the old motor with the new one and secured it into place, which was very simple--just a matter of unplugging the old motor's connection; plugging in the new one; securing the motor in place with one screw; closing up the hinged bottom; putting in the new coupler; and checking to see if it works. It did! Read more

• Tray won't turn

Just installed the items purchased from you. Read more

I attempted to diagnose the four thermostats/thermal switches in the microwave....two right behind the control panel, one on top of the cooking cabin, and one under a metal shroud above the magnetron. While checking continuity with a voltmeter, i questioned one of them behind the control panel and the one above the magnetron. I then noticed a burn mark on the plastic connector sleeve for the one above the magnetron. I took a scrap piece of 14 gage copper wire and beat the ends flat with a... Read more

Unplugged power cord. Removed the microwave from over the range. Removed vent and screws on of microwave, which allowed me to remove compartment containing sensor at upper left area of microwave. Removed clamp holding sensor. Removed and replaced sensor. Reversed process and reinstalled unit. Read more

After receiving the part, I found I had to dismantle the left side of the handle in order to fix the right side that was broken. When I took the left side of the handle off I found the plastic piece that broke on the right side was about to break on the left side also. Having all the details and in advance of another broken handle, I ordered the part, just to have when it breaks. Read more

Main Fuse did not open, only fuse for high voltage section was opened. Prior to the fuse blowing a louder than normal hum was heard from microwave for 1-2 seconds prior. Easy fix is the high voltage capacitor, so first checked the voltage across the capacitor terminals to ensure capacitor was discharged. Typically should be reasonably discharged within 30sec-1min assuming drain resistor is still in place. Removed the high voltage cap, and checked the capacitance and did not get a reading.... Read more

Found the hi voltage transformer burnt out due to just being tired, checked all other components and every thing checked out ok. I started my career in Appliance repair 55 years ago so I have a little knowledge of the workings. I use you guys because of you great prices and fast delivery service. Well continue to use your products in the future. Read more

I used a voltmeter to test continuity on parts. I found 2 thermostats burnt out. I replaced all of the thermostats and also changed a capacitor. It now works well! Read more

• Exhaust fan not working
• Noisy

• broken bulb