Thermador Range SGS304FS Parts

Used to hold down the jet holder assembly.

Mounting screw for gas range and cooktop assembly. Secures internal components and burner assemblies. Replace if corroded, stripped, or missing.

Fix a burner that won't light or sparks weakly with this gas cooktop igniter. Remove the burner cap and brass nut to access. Takes 5-10 minutes to install.

Burner won't spark or ignite? This spark switch signals the ignition module to light gas burners. Common DIY repair with basic tools, 15-30 minutes.

Secures your cooktop to the countertop from below. Includes brackets and hardware. Replace if worn, deformed, or screws are damaged or missing.

Foam seal tape creates a tight seal between your cooktop and countertop to contain spills and provide heat isolation. Replace when adhesive weakens.

This is a service repair kit that includes venturi nozzle components for a gas cooktop burner assembly. The venturi mixes air with gas to ensure proper combustion at the burner. Replace this set if you experience uneven flames, yellow or sooty flames, or if the original nozzle components are damaged or corroded.

Replacement foot assembly for gas cooktop or range grates. Installs on the underside to cushion contact and stabilize the grate. Replace when worn, missing, or broken.

This small replacement sealing ring restores a watertight connection in the appliance's fluid or valve fittings, helping prevent leaks and maintain proper operation. Replace worn or damaged rings to stop drips and avoid water-related damage. What it does:

• Forms a seal at pump, valve or hose connections to prevent water leakage.
• Commonly replaced when the ring becomes cracked, brittle, flattened or deformed.
• Symptoms that indicate replacement: visible leaks, pooling under the appliance, or intermittent water flow issues.
• Protects internal components by maintaining a reliable seal and preventing water intrusion.

• Disconnect power and shut off the water supply before starting any repair.
• Inspect mating surfaces and clean away debris or old sealant before installing the new ring.
• Fit the ring evenly without twisting; avoid overstretching or using metal tools that can nick the ring.
• If the original used lubricant, use only manufacturer-recommended lubricants; otherwise install dry.

Pressure regulator for gas cooktops maintains consistent gas flow to burners. Replace if leaking gas odor, damaged vent, or worn seals detected.

Gas burners won't ignite or spark continuously? This spark module generates the high-voltage spark needed to light burners. DIY repair in 30-60 minutes.

Secure internal components with this mounting bracket. Replace if cracked, broken, or missing to restore proper fit and prevent movement inside your cooktop.

Replacement mounting bracket for gas cooktops. Secures internal components in proper alignment. Order if original is cracked, bent, or missing.

This is an electrical power cord that connects the cooktop to the household power supply. It carries electricity from the wall outlet or junction box to the appliance's internal wiring. Replace this cord if it is frayed, damaged, has exposed wires, or shows signs of burn marks, which can create a safety hazard or prevent the cooktop from receiving power.

Cooktop won't power on or has intermittent electrical issues? This terminal block with strain relief connects power supply wiring to your appliance.