Thermador Range SGS456 Parts
Genuine Bosch part
By: Bosch
Part Number: 00165301
The Float is an OEM part for Bosch dishwashers. This float senses water levels inside the dishwasher, signaling the inlet valve to refill when needed.
Causes of a float malfunctioning can be mineral deposits accumulating and weighing it down over time, or cracks in the plastic housing allowing water in.
Symptoms of a bad float include:
- The dishwasher not filling or filling slowly
- Error codes related to fill issues
- Improper water levels impacting wash results
This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.
Do-It-Yourself Stories from Customers like You
Flood switch was stuck in on position drain pump would not turn off. Rick V. • Burlington , IA • April 05, 2017
Replaced the defective float switch.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00166635
Wax motor for detergent/rinse-aid dispenser.
Do-It-Yourself Stories from Customers like You
Soap dispenser door wouldn't open David H. • San Francisco , CA • May 15, 2015
Took door off, saw that dispenser linkage was ok, I could open and close by hand, so figured the wax motor or the wiring to it were most likely the problem. I took off the wax motor ( actuator) and ran 120 volts to it via jumper wires, and it did not move at all, so figured good chance that was the problem. Found part # on your site, received new one quickly from you, put it in and works great. Thanks.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00165331
O-ring seal prevents leaks between dishwasher components. Replace when you notice water drips or moisture buildup. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
We had water that wouldn't completely drain from the dishwaser Melanie D. • Syracuse , UT • June 05, 2015
WE replaced the drain pump and it still wouldn't drain sometimes. Finally we realized that the drain hose wasn't the correct bosch hose and the rubber was starting to bend and kink where it went through the hole to under the sink.So we bought the drain hose and replaced.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00419827
Fix a dishwasher door that won't close or latch properly. This latch and strike plate assembly restores secure door closure and safe operation.
Do-It-Yourself Stories from Customers like You
Would not drain Joseph K. • Baldwinville , MA • July 10, 2015
Replaced check valve, was broken off and plugged the drain
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00267739
Rear pump housing for the washer drain/pump assembly. Replaces the worn rear housing that supports the impeller and bearing, helping restore proper draining and reduce leaks or unusual pump noises when the housing fails. What it does:
- Houses and supports the pump impeller and bearing, forming the rear half of the drain pump assembly.
- Restores a sealed mounting surface to help prevent water leaks from the pump area.
- Helps re-establish correct water flow and draining when a cracked or worn housing impairs the pump.
- Addresses symptoms such as poor or no draining, water at the base of the appliance, or loud/grinding pump noises.
What's included: One rear pump housing. Install notes:
- Disconnect power and shut off water supply before starting; drain any standing water to avoid spills.
- Remove the washer access panels and pump assembly; transfer the impeller, seals, and any hardware as required.
- Inspect and replace pump gaskets/seals and the impeller if worn; tighten mounting fasteners to OEM torque where specified.
Do-It-Yourself Stories from Customers like You
Very little water pressure coming from spray arms only sprayed about 6" Kevin H. • San Antonio , TX • August 18, 2019
Our Bosch suddenly quit washing the dishes properly after 15 years of faithful service. I observed that there was no pressure coming from the sprayers, and determined it to be the circulating pump. I could reach into the pump from inside the dishwasher and could feel that something was loose in there - the impeller moved when pumping, but I could stop it with my finger.
When I took the pump out and disassembled it, the impeller was in two pieces (the front and back pieces that are supposed...
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00188954
Secures your cooktop to the countertop from below. Includes brackets and hardware. Replace if worn, deformed, or screws are damaged or missing.
Do-It-Yourself Stories from Customers like You
Bought bosch cook top display at box store no regulator or clips bosch never responded Laurin B. • Canton , NC • January 19, 2015
Bought parts needed. Quick turn around from y'all. All is good cause mama's happy.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00188979
Foam seal tape creates a tight seal between your cooktop and countertop to contain spills and provide heat isolation. Replace when adhesive weakens.
More
Genuine Bosch part
By: Bosch
Part Number: 00189012
Color: black. Measures about 2 inches in diameter.
Do-It-Yourself Stories from Customers like You
Normal wear from cleaning removed the markings on the bezel's Michael C. • Thousand Oaks , CA • September 21, 2015
Replaced the bezel's
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00165258
Black adapter connects dishwasher drain hose to another hose or fitting for secure wastewater routing. Replace when cracked, loose, or missing for leak-free.
Do-It-Yourself Stories from Customers like You
Dishwasher drain hose developed a small leak James W. • Salinas , CA • November 17, 2019
Ordered a new drain hose and coupling to attach to the garbage disposal. Parts arrived in less than a day, awesome. Watched video on your site showing how to do it. Video is good but I needed to remove from base plate and side panel attached with star screws to get to the point the video showed.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00165246
This individual control button allows you to select specific wash programs and time settings on your dishwasher's control panel. It registers your selections and sends signals to the main control board. Replace it if the button doesn't click properly, feels stuck, or doesn't respond when pressed.
Do-It-Yourself Stories from Customers like You
Dishwasher could not be ran in different modes Ed M. • Lawnsdale , AR • October 22, 2016
I had to replace the plastic schell around the control modguie, manufacture wanted to sell you the complete modgule
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00441905
Traps food debris and particles in your dishwasher sump. Replace when clogged with hard water deposits or buildup affects cleaning. Verify fit by model.
Do-It-Yourself Stories from Customers like You
11 years old and all plugged up Richard R. • Boyds , MD • August 15, 2015
The wash arms and filters were plugged with calcium and no longer spraying. Needless to say this impacts cleaning. The replacement parts were top quality and fit perfect. This simple replacement of parts put new life in trusty Bosch.
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00188974
This jet holder mounts in the burner assembly for a 12,000 BTU burner. It positions and secures the orifice (jet) and helps seal and align the gas path so the burner lights reliably and produces a steady flame.
- Holds and aligns the burner orifice for the 12,000 BTU burner
- Provides a sealed passage from the valve to the burner head
- Helps restore proper flame height and pattern when the original holder is stripped, cracked, or corroded
- Common symptoms: weak or uneven flame, burner won't light, or jet/orifice will not seat securely
What's included: 1 jet holder Install notes:
- Shut off gas supply and power; allow the appliance to cool before starting
- Remove grates, burner caps, and burner head to access the holder
- Transfer the existing orifice/jet to the new holder; tighten fittings carefully—do not overtighten into soft metal
- Reassemble, restore gas, and perform a leak check with an approved solution
More
Genuine Bosch part
By: Bosch
Part Number: 00298556
Connects the sump to the pressure chamber in your dishwasher. Replace if cracked, leaking, age-embrittled, or damaged. Includes 2 o-rings for secure fit.
Do-It-Yourself Stories from Customers like You
Leaking 2003 Siemens dishwasher. Gus F. • Lake Oswego , OR • April 29, 2023
Replaced 20 year old hoses, age-embrittled with pinhole leaks. Leaks only visible from the side under pressure, so had to jury rig dishwasher in garage to diagnose
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00188985
Air-gas mixing tube that connects the orifice to the burner head on gas cooktops. Replace if clogged, damaged, or missing to restore proper flame mixing.
More
Genuine Bosch part
By: Bosch
Part Number: 00151866
Seals the NTC temperature sensor port in your dishwasher to prevent leaks and ensure accurate temperature readings. Replace if leaking or worn. Verify fit with your model number before ordering.
More
Genuine Bosch part
By: Bosch
Part Number: 00165280
Circular sealing gasket creating watertight joints between dishwasher components. Replace when flattened or cracked to prevent leaks. Confirm fit by model.
More