Parts for Thermador PRD364EDPG-01: Pcb's Parts

Fix an oven that won't heat, turns off unexpectedly, or cycles on and off. This control board manages heating elements and temperature regulation.

Small hardware pin that secures or pivots components in gas ranges and cooktops. Replace if worn, missing, or broken to restore proper alignment.

If your gas burner won't ignite or clicks continuously without lighting, the spark module may have failed. This electronic component generates sparks reliably.

This factory fixing kit supplies the OEM hardware required to secure the appliance or designated components during installation or service. Replacing missing or damaged fasteners restores a solid, aligned mount so the unit stays stable without shifting, rattling, or gaps.

• Provides the correct hardware to fasten parts per your model's installation or service instructions
• Replaces stripped, corroded, or missing screws/clips that lead to looseness
• Helps maintain alignment and clearances to prevent gaps, rattles, or vibration
• Typical symptoms: loose mounting, panels that shift, or movement when opening/closing doors or drawers

• Disconnect power; shut off water or gas if applicable before starting work
• Follow the model-specific installation/service manual for attachment points and sequence; use the proper driver bit and do not overtighten
• Verify the unit is level and securely anchored; check clearances and operation after securing

This cable harness routes power and signals between key components to restore reliable electrical connections and normal appliance operation. Replace a damaged harness to fix intermittent power, control failures, or non-responsive functions. What it does:

• Provides the multi-conductor wiring path that links control boards, sensors, and motors
• Carries low-voltage signals and/or line power needed for normal appliance functions
• Commonly replaced when wires or connectors are damaged, burned, or corroded
• Can resolve symptoms such as intermittent operation, no power to components, or control errors

• Disconnect all power before accessing wiring or controls to avoid shock
• Route harness along original clips and channels to prevent pinching or chafing
• Inspect connectors for damage and replace if terminals are loose or burned

This cable harness connects appliance wiring circuits to controls and components to restore proper electrical routing and signal transfer. Replacing a damaged harness helps stop intermittent failures and restores reliable operation. What it does:

• Routes power and control signals between modules, switches and sensors
• Replaces frayed, cut or burned wiring that can cause shorts or loss of function
• Helps resolve intermittent operation, control errors or no-power symptoms tied to damaged wiring
• Matches OEM connector groupings and color-coded wires for correct reconnection

• Disconnect power (unplug or shut off breaker) before inspecting or replacing the harness
• Label or photograph connections before removal to ensure correct reassembly
• Secure harness away from sharp edges and heat sources; avoid stretching wires
• If you find melted insulation or burned connectors, inspect surrounding components for damage

If your gas range burners won't light or ignite intermittently, a worn ignition cable may be preventing spark delivery. Restores reliable ignition.