Parts for Ge APSD10JASBW1: Portable Air Conditioner Parts

This drain plug seals the washer drain opening to prevent leaks and direct water flow into the drain system. It restores a proper seal so the appliance can drain reliably and helps avoid water pooling under the unit. What it does:

• Seals the washer drain opening to prevent water leaks at the base
• Directs discharged wash water into the drain system for proper drainage
• Common symptom fix: water pooling under or around the washer after a cycle
• Common symptom fix: intermittent leaking from the bottom/front of the cabinet

• Disconnect power and water supply before servicing.
• Access may require removing the rear or front lower access panel depending on model.
• Inspect mating surfaces and any gaskets; clean debris before installing for a proper seal.
• Hand-start the plug, then snug—avoid over-tightening to prevent damage.

This window kit provides the exhaust pass-through and adjustable panels needed to vent a portable air conditioner through a window, helping direct hot air outside and reduce room heat buildup. What it does:

• Forms a sealed opening in a sliding or vertical window for the AC exhaust hose
• Secures the exhaust hose to the window to prevent disconnection or leaks
• Helps block drafts and outdoor air from entering around the exhaust opening
• Reduces hot air recirculation back into the room when the AC is running

• Designed for use with compatible portable air conditioners; follow the appliance manual for proper placement
• Measure your window opening and adjust panels for a snug fit before tightening
• Use appropriate fasteners for your window type; avoid drilling into window frames that could impair operation
• Disconnect power to the appliance before making any adjustments near the exhaust connection

This handheld remote control operates the portable air conditioner's basic modes and settings so you can change temperature, fan speed, and timer from across the room. Designed as a direct replacement for the original remote. What it does:

• Sends infrared commands to control power, mode (cool/fan/dry), temperature and fan speed
• Lets you start or stop the unit and set timers without using the unit's onboard controls
• Restores remote convenience when the original remote is lost, damaged, or unresponsive
• Matches factory functions and button layout for straightforward use

• One replacement handheld remote control

• Install or replace the batteries (check polarity) before first use
• Point the remote at the unit's IR receiver and keep line-of-sight for reliable operation
• If the remote does not work, verify batteries and that the unit's IR receiver is unobstructed
• For model-specific pairing or troubleshooting, refer to your owner's manual