Power Kraft Tractor

This part is a replacement washer. This is a genuine OEM part made by MTD and has been sourced directly from the manufacturer. This part can be used to replace a broken, lost, or defective flat washer in a variety of outdoor power equipment. Washers are a standard piece of hardware with a wide variety of uses. They can be used with various equipment components to ensure they are secured properly together by providing a greater surface bearing area for screws and bolts. When working on or near an engine, it's important to make sure the equipment is powered off and completely cooled down before starting any repairs. For more accurate information on how and where to install this washer, the appropriate owner's manual and equipment diagrams should be utilized.As an authentic replacement part, this washer is suitable for use on several different models of line outdoor power equipment manufactured by MTD, Craftsman, Troy-Bilt, and other brands. This is a genuine part made of high-quality, durable metal and is sold individually.

This is a thrust bearing. The thrust bearing is positioned between the lawn mower's spindle and front axle and serves to reduce friction during use. This part makes shifting between different speeds much easier. A worn-out thrust bearing will have more room between the rollers on the outside of the bearing. This movement will cause the bearing to move more than usual. When the bearing goes bad, the driver may notice rattling, squeaking, or other noises coming from the machine. These noises can be more prevalent when the clutch pedal is engaged. To replace the thrust bearing, first, the clutch must be removed from the lawn mower. On the bottom of the driveshaft, there is a bolt and washer that need to be removed. Wedge and move the clutch, allowing it to work its way down the driveshaft, then remove it. There is a bearing retainer clip and three bolts that will enable the thrust bearing to be removed. Repeat the steps in reverse after installing the new component.This product is a genuine OEM MTD part sourced directly from the manufacturer. The part is sold individually and not available with any other components. This product is compatible with MTD and Cub Cadet products.

This part is a replacement gas gauge. This is a genuine OEM part made by MTD and has been sourced directly from the manufacturer. If the current gas gauge is broken or in any way damaged, this part can be used as a replacement. It is intended for use with several lawn tractor models.The gas gauge both measures the amount of fuel residing in the tank and seals the fill spout of the fuel tank. This ensures that no dirt, debris, or contaminants can enter the tank and pollute the fuel supply. It also prevents fuel from spilling out. When working on or near an engine, always ensure that the equipment is powered off and completely cooled down before attempting to undergo any repairs. For more accurate information on how and where to install this gas gauge, the appropriate owner's manual and equipment diagrams should be referred to. This gas gauge is suitable for use on a variety of lawn tractor models manufactured by MTD, Troy-Bilt, Yard Man, Bolens, Cub Cadet, Husky, and Yard Machines. It is a genuine OEM part and thus is made of high-quality, durable materials. This part is sold individually.

This replacement part is a casing clamp. It is a genuine replacement part made by MTD. This part is typically used to secure the governor control plate to the tank assembly.A new casing clamp might be needed if the current one is damaged or missing. Be sure the machine is stationary and the engine is completely powered down before beginning this repair. This part is made of durable metal so that it works properly with the machine at hand. Refer to the owner's guide for more information on this part. This air cleaner is a genuine OEM replacement part. This part is sold individually and is sourced directly from the manufacturer to ensure a proper fit.