Parts for Kitchenaid KUDS22HT0: 05 - Pump And Motor Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

This part has been discontinued and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued and is no longer available.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

This part has been discontinued by the manufacturer and is no longer available.

10-16 x 1/2 inch screw secures panels, trim, and brackets on appliances. Replace missing, stripped, or damaged fasteners to restore secure fit.

This small black clamp secures a hose, tube or wiring harness to prevent movement and abrasion. It's a direct-fit replacement used to keep connections stable so lines stay routed and protected during normal appliance operation. What it does

• Holds small hoses, tubing or wiring harnesses firmly in place
• Prevents chafing and accidental disconnection from vibration or movement
• Helps maintain routing to reduce stress on attached components
• Commonly used where a compact, non-corrosive clip is required

• Disconnect power before servicing any electrical appliances
• Use appropriate hand tools; avoid over-tightening which can damage hoses

This part has been discontinued and is no longer available.

Includes drain impeller kit, relay and gasket.

This clamp secures a flexible appliance hose to a fitting to help prevent leaks and keep connections tight. It's a small but essential part that restores a proper seal on water or drain lines. What it does:

• Holds a hose firmly to a tailpiece, barb or connector to reduce leaks and hose slippage
• Helps stop intermittent dripping or pooling caused by loose hose connections
• Restores a proper seal after hose replacement or maintenance
• Works on common appliance water/drain lines where this clamp style is used

• One hose clamp

• Disconnect power and shut off water to the appliance before starting any work
• Allow the appliance and hoses to cool if recently used; use gloves and eye protection
• Use appropriate pliers or a screwdriver (depending on clamp style) to remove and install the clamp; avoid over-tightening
• Inspect the hose and fitting for damage; replace the hose if cracked or worn

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.