Bill A June 26, 2017 for Model Number SHE43P06UC/60 Cycles times have increased to almost 2 hours and then remains at 1 min until we cancel the cycle and then the unit will drain. Dishes seem to be clean and water is hot while cycling. Any suggestions what to look for? Appreciate any advice you can offer.
1 Answer Bill, You will want to look in the base of the unit and make sure that there is not water in the base which could cause this issue to occur. Read More...
Ellen June 26, 2017 for Model Number SCHE44C02UC My Bosch dishwasher keeps running with 1 min left and has to be manually stopped. There is soap and water at the bottom. C1 and PO comes up on the display when I do the diagnostics and the rinse & hold light flashes and the quick wash light is on. I tried checking the check valve and impellar to no avail. Please advise Thank you
1 Answer Ellen, You will want to check the heater and thermostat for the unit as the unit not heating properly will be the most likely cause for this issue. Read More...
Joseph November 02, 2016 for Model Number Bosch SHU66C05UC/43 (FD 8703 00346) Dishwasher will run for prolonged time with only 1 minute displayed. When stopped, it will drain but dishes are never perfectly clean. Repair man said it was 100% the control board and offered to sell a new dishwasher. Is it the control board? If so, what part?
1 Answer Hello Joseph. Remove the side cover and look for a water leak in the bottom. Usually the extended run time on 1 minute is a float stuck or water leak issue. Make sure there are no leaks and the float is not stuck. If not, then it may be the board. Read More...
Narvin K. May 08, 2016 for Model Number SHU66C05UC/43 My dishwasher will continue running for hours showing 1 minute remaining time on display. When I open the door it is stop running and there is water inside. If I drain it the pomp will work and the water will drain away. The very little amount of water remaining when I remove the filter on the base is not clear and the dishes are not shining, but with stains. They are hot.
1 Answer Hello Narvin, This is most likely a bad water inlet valve causing the flood switch to activate. The solution is normally to replace the water valve 00607335 and clean the water from the base. Read More...
Jim M January 28, 2016 for Model Number SHE43F05UC / 50 Bosch DW will not shut off automatically. It runs through the wash cycles until the front panel reads 1 minute yet it will keep going until we stop it. Other info: -Tried trouble shooting ideas in manual ranging from cleaning out filters, running the suggested button pushing tests and received an E1 error code (?) -Have hot water heater cranked all the way up. -dishes do not come out clean regardless how long we run it. Suggestions? Parts?
1 Answer Jim, This is a no drain error. If the pump is running, but not draining, and the hoses are clear, you will need to replace the drain pump on the unit. Read More...
Scott January 24, 2016 for Model Number SHE43M05UC/53 I have an issue where the cycle for full and quick wash get stuck on 1 minute and continues to run until I hit cancel to stop the cycle and allow it to drain. If I use the auto wash cycle, the machine runs to completion (0). I replaced the control board, but the issue persists. Thanks, Scott...
1 Answer Scott, This is a no drain error. If the pump is running, but not draining, and the hoses are clear, you will need to replace the drain pump on the unit. Read More...
Vick December 17, 2015 for Model Number SHE44C05UC/22 The dishwasher cycles are increased and sometimes run for over an hour. From the research I've done looks like that the control board is bad. What model of the control board do I need and where can I order one? Vic
Cliff September 24, 2015 for Model Number Bosch SHE44C05UC/40 Two weeks ago, the dishwasher started taking a really long time to complete a cycle. Then last weekend, it stopped draining at all. Based on user forums and the fact that the drain pump had been quite noisy for some time, I assumed (often a mistake) that it was the pump. So I ordered and replaced the pump. Here's where it gets tricky. Upon starting the dishwasher after pump replacement, I heard an audible pop near the control board. The dishwasher then preceded to run through a short rinse/hold cycle, but again failed to drain. I have tested continuity of the drain pump and the lines to the pump - both tested positively for continuity. I have also tried resetting and running diagnostics, after which a I received a C1/PO error code followed by an E1 code. I have read several forums that state the E1 code indicates a problem with the heating stage (which would lead to prolonged wash times) and that the issue is likely an overloaded 10A relay switch on the board. That may be the case, but what do you make of the failure to drain and the pop I heard? I have no problem with replacing the control panel, other than the fact that Bosch apparently installed relay switches that are way too close to max load. However, I don't want to spend another $130 + if that's not the issue. Thanks in advance for your input.
1 Answer Hello Cliff. Test for power to the pump. If it is not there, you will need to replace the control board. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Matthew August 05, 2015 for Model Number Bosch Dishwasher SHE43F05UC/50 The dishwasher will run until it gets to 1 minute, and continues running indefinitely. When I open it at the 1 minute readout, there seems to be a build up of soap and water in the bottom. I checked the pump impeller for any blockage and found none. Any idea which part needs replacement?
1 Answer Hello Matthew. This is a no drain error. If the pump is running, but not draining, and the hoses are clear, you will need to replace the drain pump on the unit. Read More...
Nelson July 20, 2015 for Model Number bosch fd7805 Dishwasher tub gets water from the sink drain, how do I drain the dishwasher from the control panel. I will fix the sink drain so no more water come back into the unit.
1 Answer Hello Nelson. If you turn the dishwasher on cancel, I should drain out the water. Read More...