Peter June 18, 2012 for Model Number SHU5302UC-O6 What does it mean when the letter "F" appears on the control panel? The motor starts, drains the little bit of water in machine and motor keeps running but does not fill. Checked the filters, coarse and fine, but they are clean. I tried the reset by selecting proper buttons. Get "CL" on display, but when I turn it on again, I get the "F." Thanks.
1 Answer Hello Peter, This sounds like there is a leak under the unit causing the flood fault to appear. Most of the time, this will be caused by the water valve not opening all of the way and causing a dribble from the water inlet to dribble into the base plate. You can check this by removing the kick panel with the power turned off, and using an inspection mirror to check for any water in the base. If any water is present, you need to use a towel, (not washed in fabric softener so it will absorb the water), and once the water is gone, start the unit back up and watch the area up and to the left of the water inlet valve. If you see a dribble dripping down, replace the water inlet valve. As long as all of the water is gone, this should correct the situation. Read More...
Elaine January 14, 2012 for Model Number shu6806uc/u06 Only one control button works now. Others have worn out/broken off. Do I need to replace the whole module or does the cover part contain the tabs that I need?
1 Answer Hello Elaine! The control module front cover 00264946 does not include the buttons, they are separate. The program button on the right of the control panel is part number 00168561, part comes one per package. The on/off button is part number 00168562. If you are needing the ribbon cable it is part number 00189498. Hope this helps, thanks! Read More...
Therese November 21, 2011 for Model Number SHU5312UC/U06 The buttons on control panel stuck on in position will not trurn to off position for another function to work
1 Answer Hello Therese. Check and make sure the buttons are not broke. If they are good, you will need to replace the module 00266746. Hope this helps. Read More...
Moe August 16, 2011 for Model Number shu4002uc/u06 Sometimes the dishawasher goes through an entire washing and drying cycle with no problem (about 45 min.). Other times the timing seems to get hung up and will stay in the same cycle for hours.
1 Answer Hello Moe. With the Bosch dishwasher, the cycle times vary based on water temperature and the soil level of the dishes. According to Bosch, the cycles can go from 45 minuets up to 8 hours, depending on the temperature and soil level. If this is the first time you have had this unit do this, you will want to check the heater. If it is good, replace the module 00264946. Hope this helps. Read More...