Customer Questions and Answers for Dispenser by Bosch

Hi Harvey. It clarifies something I did not realize when you sent the pictures. I apologise but there are 2 different series of your model # and I only knew of the first one. Anyway, Yes , the detergent latch w/spring should be exactly what you need part # 00166630. You can also create a log in on our web page. Then insert your model # in the parts search and on the left, scroll down to the door Assy. You must have already have been there. There is the exploded view of # 15 , # 19 , #20 and # 21 are all suggested parts because since you are in there it may pay to have it all new since rubber parts deteriorate. Thank You.

Hello Fred! The replacement dispenser used on your Bosch Dishwasher model SHU4326UC/12 is part number 00490467. Thanks!

Hello John. Here are the instructions from the manufacture. Hope this helps. To remove/install dispensers:
Remove outer door, remove fascia panel & disconnect wire harnessfrom fascia panel.
Disconnect wire harness from above dispenser, then remove wires to wax motor & reed switch.
Disconnect condensation tube (for older models with condensationtubes in doors).
Bend retainer tabs, the push dispenser inward toward tank. Protect hand with towel as edges are sharp.
Replace from inside of tank --position O-ring seal and bend tabs to secure. When replacing dispensers, lubricate O-rings with rinse-aid & support inner doors to avoid damage if O-rings stick.

Hello Eric. No, you will need to take the door apart to replace the dispenser 00490467. It has screws on the back holding it into place. Hope this helps.

Hello Ed. You will need to test and see if there is power coming to the dispenser 00490467. If not, you will need to replace the control module 00266746. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Hi Don. Yes we can try to assist you if you can send us a E- Mail address we can send it to . Thank - you.

Hello Don. The difference is the design of the dispenser. According to the model number you provided, 00488964 is the correct dispenser. If you provide your email address, we can send you the manual. You will not need sealing cement for the repair. Hope this helps.

Hello JME. We will need your email address to send you the manual. Thanks.

Hello Cindy! Please resubmit with your e-mail address in the question body (we will not post this) and we will be glad to send you a copy of the service manual. Thanks!

Hello Cindy! Please resubmit with your e-mail address in the question body (we will not post this) and we will be glad to send you a copy of the service manual. Thanks!