Mary Alys Kratzke January 29, 2014 for Model Number Kenmore electric range Model 790-94212400 While preheating the oven, it made a loud "POP" sound and blew the circuit breaker. We reset the breaker. The oven does not work, nor the broiler. I think it is the element. Could it be something in addition to the element? The rest of the range works fine. I could order replacement elements, but I am afraid it might be more than the elements. Please advise. Thank you. Mary Alys Kratzke
1 Answer Mary, While it is possible that the element is the issue but it sounds like since the broil and bake are not working that you would want to check the terminal block to make sure that there is no damage to it. If that checks ok then it may be an issue with the control board of the unit. Read More...
Cold Oven Owner October 31, 2013 for Model Number 790.9641240B Oven doesn't heat. Broiler element works and visual inspection indicated bake element burnt. Replaced part 316206000 but still does not heat. Ohm reading on element is 16 on a 400 scale. Both old and new are same reading. Is that spec correct for a working element?
1 Answer Hello. If the element is new, you will need to order and replace the oven control board on the unit. Read More...
Bill April 08, 2013 for Model Number 79092309012 On part number 316206000 what is the correct ohm reading on the good part? What would a reading of 16 ohms mean?
1 Answer Hello Bill, This means that this is a 900 watt element. We do not have the technical information available on specific Frigidaire built units. The information should be on the tech sheet either on the rear of the unit or in the drawer area, (the drawer usually has to be removed to access the tech sheet if it is in the drawer area). Read More...
Jean March 31, 2011 for Model Number 79096213408 I see the boiler with 3 bends. Where is the oven element with 4 bends ?
1 Answer Hello Jean. It is located under the bottom panel in the oven. You can remove the panel by removing the two screws in the back and lifting the panel out. Hope this helps. Read More...
1 Answer Hello Jean. Disconnect the power going to the unit. Remove the screws holding the element in place. Pull the old element out and disconnect the wires. Reinstall the new element in reverse order. Hope this helps. Read More...