Jsh May 26, 2018 for Model Number FEF366BCC I have an electric Frigidaire range purchased in 2003 Model FEF366BCC. Some times the oven will heat up and sometimes it will not. Broiler works, but the heating element at the bottom sometimes fails to get hot. We tested the adjust oven temperature and it read zero. We replaced the heating element but that has not fixed the issue.
1 Answer JSH, Check the wiring to the bake element from the control board to make sure that it is good but sounds likely that the oven control board will be the most likely cause for the bake not working. Read More...
Melinda D. April 07, 2018 for Model Number FEF336FMF My clock works fine and the element is good but my oven will not work.
1 Answer Hello Melinda, This will most likely be a bad control 5304518660 if there is no voltage supply problem to the unit. Read More...
1 Answer Hello Kerry. Test the elements and make sure they are good. Then test the sensor. If all is good, replace the control board on the unit. Thank you. Read More...
Lisa April 25, 2017 for Model Number Fef366awa My bottom element went out so we replaced it. The new element is good but won't work. Everything else works.
1 Answer Hello Lisa. If the element is new, you will need to order and replace the control board 316207522. Read More...
Pam H April 21, 2017 for Model Number FEF377CFTE After baking cookies took them out and ready to put the next batch in and the oven door was locked open and would not close to bake again. The oven is in locked mode.
1 Answer Hello Pam. If it does not clear out, you will need to order and replace the control board on the unit. Read More...
George S March 31, 2017 my Frigidaire gas range es200/300 gives me a f3 error code when I try to start my oven, what is wrong
1 Answer George, To properly assist you we will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Scott February 13, 2017 for Model Number FEF366BCC Clock works, lights work, but none of the heating elements work, oven or range or broiler.
1 Answer Hello Scott. You will need to test for 240 volts at the terminal block on the unit. If there is only 120 volts, the lights and clock will work, but you will get no heat. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
1 Answer Hello Meaghan. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Bill June 01, 2016 for Model Number FGES3065KFD My Figidaire oven will not come up to temp after the Self Clean function was run. Takes forever just to warm up to 200 degrees. Thanks
1 Answer Hello Bill. Check both elements and make sure they are good and if so, you will need to test the thermostat 318578506 on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...