Ted February 02, 2012 for Model Number GLD2445RFS2 We select Normal Wash dishwasher cyles thru from 96 minutes to 84 minutes then PF is on display, as well as NO HEAT DRY and HI TEMP WASH. We then push Start/Cancel and the dishwasher does the same thing as above. It will not complete an entire wash and dry cycle.We did not have a power falure of any kind and we checked the electrical outlet it was ok. Any solution?? Thanks!
1 Answer Hello Ted. Based on the information you provided, it sounds like the control board 154663004 is bad and will need to be replaced. Hope this helps. Read More...
Thomas November 13, 2011 for Model Number gld2445rb0 Our dishwasher cleanes the dishes then when its time to dry it kicks off and just shows power failer on the front of the dishwasher. Would it be the electric panel or the heating element or what could it be?
1 Answer Hi Thomas. The heater needs to be checked to see if it is open or ohms out to 28-38 ohms. Is it shorted and pulling too many amps as it will open the thermostat part # 154290204. Keep in mind that the thermostat will reset, however it is always best to change the heater and thermostat at the same time. If it is a power failure, while you are changing these parts , make sure you dont have any loose connections in your junction box not allowing you to pull the amount of amperage needed for the heat circuit. First remove power for safety. Thank You. Read More...
Ginger May 21, 2011 for Model Number FDB2415LFSO When we select a cycle on our dishwasher, the pump kicks in, even before we start the cycle, and even if there's no water to be pumped out. We tried the water/service test, and it would not do it manually, making us think the timing isn't right. Would this part make the problem(s) disappear?
1 Answer Hello Ginger. You will need to check the float switch 154773201 and make sure it is not stuck in the up position or bad. If it is good, then the control board could be the problem. You can test this with a multi-meter MA-DM1. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...