Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Refrigerator Freezer Electronic Control Board (White) by Frigidaire

Best Seller
Manufacturer Part
4.89 (64)
By: Frigidaire
Part Number: OEM15956754
Manufacturer Part Number: 297370600

This electronic control board includes the user-facing touch pad display panel and the circuit board that manages freezer temperature settings and functions. It mounts on the exterior of the freezer compartment and allows you to adjust temperature and other settings. Replace this board if the display is blank, unresponsive, shows error codes, or if the freezer is not maintaining the correct temperature despite other components working properly.

More
$118.95

IN STOCK
Ships Tomorrow Guaranteed
Add to Cart

Questions & Answers

For Frigidaire Refrigerator Freezer Electronic Control Board (White) (Part Number: OEM15956754)

1 Answer

Hello Terry. Try unplugging the unit for about 15 to 20 minutes and resetting the system. If problem continues, you may need to replace the electronic control 297370600 in the unit.

Read More...

1 Answer

Hello Paula. If the board 297370600 is bad, the lights inside can still work. If the unit is not cooling and the board is bad, you will need to replace the board in the unit.

Read More...

1 Answer

Hello Howard. The defrost cycles in the control board 297370600 do not use any time cycles. It is based on the compressor run time, and amount of time for the thermostat to terminate in the unit. There is no way of giving you set times on the defrost cycles.

Read More...

1 Answer

Eddie, Sounds like you had a voltage spike or brown out, and the control board is damaged 297370600. Power to the freezer components goes to and through the control and out. If the board fails nothing will work. Check and make sure you have 110-120 VAC at the outlet, check the power cord for damage, then replace and program the electronic control. Good Luck and Thanks

Read More...

1 Answer

Hi Betty. Is the door sealing level and tight? If not then re level the unit and find out why the door is not closing correctly. Are there any food oddly placed allowing the door to remain slightly open ? The freezer fan will continually run if the temperature demand is not satisfied. There is a thermistor part # 297018400 that reads 10,000 ohms while at 77°. I would use the digital capacitor Tester / Volt/ohm meter part # MA-DM1 . It is mounted by the evaporator behind the back wall. This will allow continual run. If not then replace the control part # 297370600. Thank You.

Read More...

1 Answer

Hi Dee. It really depends on which hinge the wiring harness passes through. I believe it passes through the bottom hinge since the wire harness goes under the unit. Then you need to stay away at the square routing pass in the door insulation. You may be able to remove the half (upper or lower) of the inner door panel screws to see where the wire is internally routed. It is usually taped over inside. Great question as I hope you let me know what you find. It seems as if the panel trim mount screws just enter the outer door frame, it will be ok. Thank You.

Read More...

1 Answer

Hello George. Yes, the control 297370600 is the defrost timer for the unit. You will remove it from the front of the door. It unsnaps out of the door. Hope this helps.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google