1 Answer Hello Mike. The controller 5304491584 is used to start and run the compressor. Hope this helps. Read More...
Jbp November 02, 2011 for Model Number Part# 216649313 I need to order part #216649313 but in the picture, it doesn't show any wire coming out. I had to cut the wire to get it of the freezer but need wires to hook back up. Is it wired?
1 Answer Hi Jbp. You can use the terminals part # TJMA02589-1 and part # TJMA03018-1. Along with a crimper tool part #MA-30428 to reconnect new ends on the wire. You can use needle nose pliers to break away the side walls of the relay control to visibly see the center locking tabs on the original terminals. Use a pick tool to reach in and relieve the connector as you pull the wire off. Then use butt-splices to reconnect each wire together again. Butt- splice part # TJMA02522-1. Controller part # 5304491584. Thank You. Read More...
Mike June 29, 2011 for Model Number GFU14F3AW2 Stopped freezing all of a sudden. Fan is working but not the compressor. Any suggestions as to the possible problem?
1 Answer Hello Mike. Here is a link to our Repair Forum, this is a free service to our customers. Use this link to access the repair for your question. Hope this helps. http://forum.appliancepartspros.com/refrigerator-freezer-repair/193358-freezer-fridge-not-cooling.html Read More...
Steve R. April 27, 2011 for Model Number GFU17M4AW4 I don't have a start relay but a controller. I have it off of the compressor. There are three pins and how do I know which one to check? Also I'm taking the controller down to an appliance store they said they can possibly check it out to see if its good or bad.
1 Answer Hello Steve. The single pin is the common, and the pins beside each other are the start and run. Usually the one on the right is the run and the one on the left is the start. Hope this helps. Read More...
Steve R. April 25, 2011 for Model Number GFU17M4AW4 HI. This is the actual part # 216649313 your part # is AP2113686. This is not the original compressor, it was replaced about 3 years ago so. It doesn't have a start relay, but a controller and is there anyway to tell if it is bad.
1 Answer Hello Steve. You will be able to check the compressor and see if it checks out ok. Here is a link to our Repair Forum, this is a free service to our customers. Use this link to access the repair for your question. Hope this helps. http://forum.appliancepartspros.com/refrigerator-freezer-repair/180812-refrigerator-not-cooling-fan-working-compressor-hot-but-not-running.html Read More...