Wayne February 27, 2015 for Model Number frigidaire oven fget3065kfa How do you replace the hidden bake element in top oven?
1 Answer Hello Wayne. You'll need to remove power to the unit and remove the oven from the wall in order to remove the rear panel and access the hidden bake element. Thanks. Read More...
Thebigo January 24, 2015 for Model Number EW30EW55GS2 How many OHMS will I get on the BAKE element? Thanks
1 Answer Hello TheBigO. The best way to test the element is for continuity. It should read closed for continuity. Read More...
Ski December 27, 2014 for Model Number FGET3065KFA The lower hidden bake element on the upper unit does not heat, I have replaced the temperature sensor, The units were removed and I checked for continuity on upper broil element and lower bake elements with the same reading (41 OHMS with beep) checked for continuity in the thermostat (0 with beep) but the upper unit will still not heat properly, any ideas?
1 Answer Ski, With the broiler working in the upper oven but the bake not and the bake element checking ok then the issue would most likely be caused by a faulty relay on the control board which is part number 316443911. Read More...
Steve June 22, 2014 for Model Number Kenmore Elite 790.47893604 The oven is built-in, and there isn't a panel inside the oven (as far as I can tell) to access the hidden bake element. How do I replace the element? Thanks!
1 Answer Steve, you'll need to remove power to the unit and remove the oven from the wall in order to remove the rear panel and access the hidden bake element. Thanks. Read More...
Randy T. May 02, 2013 for Model Number Kenmore elite single wall oven sealed. I disconnected the old element but did not mark which wire went to which side of the connections on the element. When I get the new one I want to make sure I connect it properly. Is there a positive and negative connection to the element. If so how can I determine ehich wire is which?
1 Answer Hello Randy. No, this is a closed circuit and there is a video on the parts page to show you how to install the part. Does not make a difference which wire goes where on the element. Read More...
1 Answer Hello Dave. You will need to pull the unit out and remove the back access panel to access and replace the element 318601604. Make sure the power is off before doing the repair. Hope this helps. Read More...