Jane H. September 16, 2015 for Model Number ATF6000FSI I took the door of my washer apart to replace the inner frame 134550700. The part arrived today but now I am having trouble reassembling the door and hanging it back on the hinge. Do you have any instructions or that would show me how to reassemble the door and hang it?
1 Answer Hello Jane, If you use the parts explosion you should have no trouble in the re-assembly. The door will then hang and bolt on the unit. I'm sorry but there are no instructions in print from the manufacturer. Read More...
Carolyn May 07, 2014 for Model Number FAFW3511KWO My Frigidaire Affinity front loading washer door hinge is broken and the plastic around the hinge on the outer door panel has crumbled away the door is usable however it's sagging and breaking I have to hold it up to open it. I think that I need the following parts: Door Panel 134550500 / Door Hinge 134550800 / Maybe Hinge reinforcement 134550900 / Do I need screws or something? :-) the washer was purchased in 09 do you think this problem was caused during the installation perhaps it was not aligned properly? Can I fix this myself or should a pro align it for me? Thanks
1 Answer Hello Carolyn, The door hinge and the door latch assembly will need to be replace. If the latch is damaged, it will have to be replaced also. When the new parts are assembled they will all align properly so you should have no problem. The existing screws can be reused for this job. Read More...
Shirley November 17, 2013 for Model Number ATF6000FS1 You said that the frame 134550700 is the inner door frame only. I am looking for the outer door. What is the part number for the outerdoor, the part that attaches to 134550700??
Dan B. September 11, 2012 for Model Number ATF6000FS0 I recently bought a home and the washer and dryer came with it. I've noticed that the door on the washer is sagging and there is a crack of the white plastic frame by the hinge of the door creeping out towards the front. It doesn't look like the hinge is bad but I am not sure could the frame being cracked cause the door to sag?
1 Answer Hi Dan. First of all, use a torpedo level on the top and make sure that it is level front to back and side to side. If it is cocked it will misaligned the striker and wear out the door latch. This may be the cause of the door frame cracking as well. Someone may have leaned on it too hard while removing clothes and started the crack. The door frame is part # 134550700. The door hinge is part # 134550800. If the hinge is loose as you test from lifting the door up and down slightly. Thank you. Read More...
John F. March 23, 2012 for Model Number ATF6000FS1 The door is sagging causing the door strike to keep breaking. I took the door apart and saw 2 small plastic tabs broken off from the door where the top and bottom of the hinge attaches. The tabs are part of the door. I don't want to keep replacing the strike. Any suggestions for a fix? Also, is there an accessible filter for this machine?
1 Answer Hi John. The door hinge part # 134550800 has 2-plastic bushings that engage the door inner panel part # 134550500. The door strike is part # 131763302. It is a floating mount strike . The screws are tight but the strike can move a little up or down. Make sure the unit is level front to back and side to side with each leg lock nut is tight up against the base of the unit. So your unit will not settle and allow the door to have these issues. Tell users to be careful of this issue. Thank You. Read More...
Tony S. January 11, 2012 for Model Number ATF6000FS1 This frame is two separate parts or two part numbers?
1 Answer Hello Tony! The frame 134550700 is the inner door frame only. What parts are you needing? Thanks! Read More...