Customer Questions and Answers for Sensor by Frigidaire

Hello Lina. Make sure the heater is working good in the unit. If so, you will need to order and replace the control module 154712101 on the unit.

Tim, You could try and clean the deposits off the sensor, using hot water and distilled white vinegar or a citric acid based cleaner. Soak the "clear end of the sensor, then use an old tooth brush to scrub and clean it, just be very carefiul. For the motor, first thing to try, remove the lower wash arm,support and filters, remove the volute cover 807145201, and use your finger or screwdriver and turn the impeller several revolutions, this should "break" the shaft seal and shaft loose and the motor may run fine from then on.

Hello Lisa. If the spray arm becomes loose, it can release and hit the heater and melt on the units. I would check and see if the arm is loose and made contact with the heater. If so, replace the spray arm in the unit.

Hello Brian. If the drain pump 154580301 is new and the hoses are clear and the sump assembly in the machine is not clogged, you will need to test for power to the drain pump during drain. If there is no power coming to the drain pump, you will need to replace the control board 154663005 if the wires are good. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Hi Kevin. Yes, the main motor kit is part # 154844101. Thank you.

Hi Sharef. Under the lower wash arm there is a gray trap that you lift up and out. Then you take the white support and twist/ lift at the same time to remove. There is a 3" filter basket under here that you need to clean . Also clean the large silver screen to clean. Clean , Clean , Clean is the name of the game. Is the spray arm full of debri's in the jet holes? Take a pick tool and rinse clean the wash arm. There shouldnt be a piece of anything broken. You need to make sure all is clean in the sump/ pump assembly. Thank you.

Hi Rookie. Check and clean all the wash arms with a pick tool under the sink. Make sure that the water manifold / funnel are all intact when the racks are in place to have delivery of the water to the spray arms. Take the trap Twist and lift off and remove the stainless lg. screen that has a filter assembly. Clean, Clean, Clean. This may help. Use dishwasher magic part # []. The pump motor is part # 154844301. Thank you.

Hello Marvin, first you will want to make sure nothing is blocking the float154767801 located inside the tub. Next you will want to look at the switch 154773201 which this float works with. You will have to access the switch from underneath the unit. If all these parts are okay, you might want to look at the water valve 154637401. Hope this helps!