1 Answer Nick, The F7 error code will be caused by a faulty keypad which will need to replace the control panel WB36T10608. Read More...
Jim R September 09, 2017 for Model Number jkp20cof6cc Ordered a new control board WB27T10409 but some pins in wire plugs sockets are not there. Are there more then one version of this board. also looking for documentation of the new part but can not find anything.
1 Answer Jim, we do not show any changes being made to this board for your model number. Please call us at 877-477-7278 so we can further help you with this part, thanks! Read More...
Frank May 18, 2017 for Model Number wb27t10409 Group of 888888 comes on-then Low -High on and off. Just replaced control oven.
1 Answer Hello Frank. Check for a stuck button. Also, try pressing clear/off to clear and use the unit. You will need to set the time on the unit also. Read More...
Cj November 25, 2016 for Model Number GE JKP20 Cooling fan does not turn off. Tried disconnecting both latch thermal switches with no effect. Did not disconnect thermal cutout switch, as rest of oven works normally. Suspect swith K6 on circuit board is sticking. Do I need to replace entire control board?
1 Answer Hello CJ. Yes if the relay is stuck, you will need to replace the control board on the unit. Read More...
Chris T. October 04, 2016 for Model Number jkp28bf3bb ge oven I had the f3 fault code. I replaced the sensor probe but the f3 came back. Any thoughts on what to check next?
1 Answer Hello Chris, You should check the resistance of the temperature sensor from the control board, (white wires that connect to pins 4 and 6) for about 1100 ohms at about 70°F. If the reading is not consistant with the reading taken at the sensor WB21X22134, the harness between the sensor and the control is the issue. If the readings are consistant, replace the control WB27T10409. Read More...
Terry March 18, 2014 for Model Number JKP20 We had power outages and used a generator. Our GE Profile oven has lost the ability to keep time, the clock and the oven timer gain about 1 minute in every 5 minutes. Is the only solution to replace the entire module?
1 Answer Hello Terry. Based on the information you provided, you will need to order and replace the control board in the unit. Read More...
Rick October 08, 2013 for Model Number JKP15WW Trying to replace the control panel -- WB27K5299. Looking to order this part.
1 Answer Hello Rick. The part number you provided has changed over to WB27T10264 on the unit. Read More...
Anthony May 29, 2013 for Model Number jkp25soh5ss My oven display comes on' but the only keys that work is the start and cancel. After several minutes, the control beeps and displays F7 DC. What does the code mean?