Customer Questions and Answers for Range Lp Conversion Kit by Ge

Hello Gary, You will need to order one of each of the following since there is no kit for converting back to natural gas from LP: WB28K10187, WB28K10188, WB28K10189, and WB28K10190. The oven compartment is adjustable by turning the orifice hoods 1 1/2 to 2 turns counterclockwise. You will also need to convert the regulator by removing flipping the large nut.

Hello Michael. You will need to order WB28X39132 for the kit needed.

Hello Lance, You will need to order conversion kit WB28K10045 for the model provided if they are not located by the gas valve behind the drawer as stated in the units' tech sheet. Convert regulator at the lower left hand rear of the range as viewed from front. Remove the drawer and false panel to access the regulator. Some models have a metal cover over the regulator that must be removed for conversion and reinstalled when the conversion is complete. Remove the large hex-nut from the center of the regulator and remove the plastic pin from the bottom side of the cap. Flip this pin 180° and snap the pin back in place. To replace the orifices, a 7mm nutdriver will be required. The surface burner orifices are color coded to aid in identifying the proper location during conversion. The coding is as follows: LF and LR Blue/Brown, RF Blue/Magenta, and RR Blue/Blue.

Jeremy, The part number for the LP conversion kit will be WB49X20214.

Hello Sam, You will need to order one WB28K10187, one WB28K10188, one WB28K10189, and one WB28K10190. The complete holders do not need to be replaced, only the orifices. This is the only way to order the natural gas orifices. To adjust the bake and broil back to natural gas, use a 1/2 inch open end wrench to turn the orifice hoods just below the burners 1 1/2 to two turns counterclockwise. Use the air shutter to adjust any yellow tipping from the flames. You will also need to locate the regulator WB19K10039 and remove the plastic cap and flip the nut under it over. This will complete the conversion.

Neil, The manufacturer does not list a conversion kit for the unit but you can get the orifices which you would need for the the Left front WB28T10017 for the right front WB28T10033 and for the Right rear and left rear WB28K10288.

David, if you're replacing the WB19K10044 Control Valve Asmb. you don't have to switch orifice hoods, the existing hood is adjustable. use a 1/2 in. open end wrench or small crescent wrench and turn the hood 2 or 3 revolutions clockwise (down), the hood will lower down on the internal LP "pin" and the valve is converted.

Hello Bridget, It looks like you will need to order WB28K85 for the model number provided.

Josh, Other than loosing the orifices on the bake and broil burner and closing the air shutters to about 1/4 way open then the conversion should be complete.

Jim, Unfortunately we are not showing this model coming up for parts. If this unit is located outside of the United States then we would not be able to locate parts for it.