Barry G. October 09, 2012 for Model Number JBP26002H1 I am looking to replace the braided oven door gasket. The model number that I found was located on the upper right side opening of the oven. The model number is not in your list. Model # JBP26 002H1. I'm sure there must be several compatible range oven door braided gaskets for other models or can you find this model and is there a specific, different part? Thank you.
1 Answer Hello Barry! For the model number you've provided the correct door gasket is WB2X3138. Thanks! Read More...
Ned June 07, 2012 for Model Number Oven GE J BP260F1WH (Rope seal WB2X3048) Directions for replacing seal says "You will need to lock the door hinges so you can lift the door off the cabinet. Lay the door on a shipping blanket on top of a suitable table top. Remove all side, top and bottom screws to remove the inner door panel. Then unclip the old gasket off the door and thread the ends of the gasket inside the door as the old one was." How do you lock the door hinges then lift door off hinges?
1 Answer Hello Ned. Open the door and look at the hinge. You will see a clip you pull down to lock and remove the door. Read More...
Snooks January 07, 2012 The hole in our wall accommodates a 22-inch Hotpoint wall oven. Are there any wall ovens out there that are that small?
1 Answer Hi Snooks. Thank you for your inquire. We assist. D.I.Y.'s in appliance parts replacements. There are however many manufactures that will have models to offer for your needs. It will be best to have your exact measurements with you so you can also get assistance if you need to have surrouning trim for the desired replacement model . Thank You. Read More...
Brian August 18, 2011 for Model Number JBP26GR2WH Should we be able to replace this gasket ourselves? Is there another one (generic) of lesser expense?
1 Answer Hi Brian. This is the factory reccommended door gasket replacement part # WB2X3138. You will need to lock the door hinges so you can lift the door off the cabinet. Lay the door on a shipping blanket on top of a suitable table top. Remove all side, top and bottom screws to remove the inner door panel. Then unclip the old gasket off the door and thread the ends of the gasket inside the door as the old one was. Take pictures if needed. Thank you. Read More...