Peter L January 19, 2013 for Model Number GE Model # JKP44GP1 The upper oven flashes error code F1. At first I could turn it off and just use the lower oven but now it keeps beeping and flashing. I replaced the control panel but it is still doing the same thing
1 Answer Hello Peter. If the control panel did not fix the issue, then the board is bad and will need to be replaced for the error code you provided. Read More...
Tom November 11, 2012 I have a GE double wall oven. I cannot locate the Themal Switch to reset top oven. Oven stays on 100 and does not heat upper or lower elements on top oven. I reset lower and works fine.
1 Answer Hello Tom. We will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
David R August 09, 2012 for Model Number jkp13gt1bb The lock light flashes and the lock mech continues to cycle. The K4 relay on the inside of the keypad clicks in and out.If you press bake or broil the diplay reads door. oven doesnt heat?????
1 Answer Hello David. Based on the information you provided, you will need to order and replace the latch assembly WB49T10020. The switches are not reading in the latch assembly. Read More...
Lawrence June 25, 2012 for Model Number jkp44gp2bg I am getting an F1 error and an alarm goes off on the upper portion of my double oven. I was going to replace the ERC Limit Switch.
1 Answer Hello Lawrence. F-1 is for Double tineBreak Relay is“ON” in a non-cooking or cleaning mode. Determine if problem is withthe Key Panel or Control by:1. Pushing CLEAR/OFF pad2. Disconnecting RibbonCable from control and waitat least 32 seconds to seeif Code re-occurs.If code re-occurs. problem is inthe Control.If code does not re-occur problemis with the Key Panel. Read More...
Asif October 16, 2011 for Model Number jkp18bow1bb Top left hand side limit switch shows open cntinuity, but oven works on bake and broil both. Initial problem start after self cleaning and control give a code 7. I reset power couple of time also. Any idea why oven is working with limit switch open?
1 Answer Hi Asif. There are 3-thermal switches with your model. One is in line with the fan motor. The other one is in line for your door lock/unlock switches. Part # WB24K5033. This is found on the wiring diagram. They were not specified to what one is the top, but my thought will be to see if the door lock (clean mode) works.Part #WB24K5085. If it does then check the conv. fan mode as well. Or use electrical tape to bypass the wires to see what circuit will momentarily work. (Remove power first, then connect wires together). Thank You. Read More...