Jessica May 11, 2013 for Model Number WSM2700 The washing machine will fill up, but will not start the cycle. I can move the knob to rinse and spin and they work fine.
1 Answer Jessica, You will want to check to make sure that when the unit goes to agitate that the motor is getting power. If the motor is getting power but not turning on then the motor is faulty and would need to be replaced. If the motor is not getting power then you will want to check the timer for sending power. Read More...
Marvin January 26, 2012 for Model Number WSM2700WCWWW First the outer tank leaked and was repaired. Then we brought the washer back inside. The washer was working properly even while the tube was leaking. But as soon as brought it back in, hooked up the hoses, the dryer trunk and plugged it in, it would fill but the washer would not agitate.The timer works, the fill switch works, into rinse and spin and drain. All that works but the agitator and the auto spin shut off of the door. The agitator is completely dead in all settings.
1 Answer Hi Marvin. Usually if the washer fills and does not agitate it is a lid switch part # WH12X10216. Try to jump the red/blu with the orange wire to see if the agitation starts. Then if this does not work, try to jump the red/blu and the white together at the pressure sw. and see if it runs in agitation. Remove the agitator to see if the trunnion plate part WH01X10437 is broke off the side of the trunnion part # WH17X95 the bolts are part # WH2X1107. Thank You. Read More...
Jim September 15, 2011 for Model Number wsm2700dawww Can't get the timers knob off. Can you give me some ideas how to get it off to be able to replace it?
1 Answer Hello Jim. There is a clip on the back of the timer WH12X10164. You will hold this clip and pull out on the timer knob at the same time to remove the knob. The timer knob must be pressed in before holding the clip and removing the knob. Hope this helps. Read More...