Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Washer Inner Door Gasket Clamp by Lg

Best Seller
Manufacturer Part
4.89 (64)
By: Lg
Part Number: OEM13310745
Manufacturer Part Number: 4861ER2001D

Secures the inner door gasket to prevent water leaks during wash cycles. Replace if gasket is loose or leaking. Confirm fit with your model number.

More
$32.44

IN STOCK
Ships Today Guaranteed
Add to Cart

Questions & Answers

For Lg Washer Inner Door Gasket Clamp (Part Number: OEM13310745)

Tony for Model Number WM0642HW

I keep getting error message de. I keep turning it off and on until it turned off and started filling up. This worked for a couple of years. Then it quit all together. I went to the book and ordered a switch for the door. I came to this site and bought a Door gasket. After replacing both by the video. I still get a de code and it want go out after replacing the parts. I was checking the wiring schematics and it has a fuse linked to the switch in the main circuit board. Could this be the problem? It looks ok.

1 Answer

Tony, the door lock is spliced before the fuse and the fuse is going to be specifically for the heater. What you will want to check is ensuring that the door strike moves properly and that the spring engages properly. If the strike does not pull down from the tension of the spring, then this can cause the de error. From there, you will want to test the wiring going from the main control to the latch for continuity to ensure that the wiring is not broken. Following that, when started, the control should send 120VAC to the lock solenoid. If the control does not send 120VAC to the solenoid, then the control is bad.

Read More...

1 Answer

Hello Andy. Yes, the video is posted under the picture of the part on the parts page.

Read More...

1 Answer

Larry, There are a couple of ways of doing this chore. It may be easiest to use a flat blade screwdriver, usually the spring will be in the 7 o'clock position, and work the metal wire around the tub as far as possible, then use the screwdriver to pry or push the remainder of the wire into position, like installing a tire on the rim of a bicycle. you can use the same process when you install the front of the boot to the front panel door opening. Thanks and Good Luck

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google