Terry April 12, 2012 for Model Number LFC25760SB I read your answer to Vic in regards to replacing the circuit board. I did disconnect the lamp sockets but it is still very difficult to remove the board. My worry is getting the new one back in without damaging it. Does that housing come apart from the control box? I don't want to break it by forcing it.
1 Answer Terry, The instructions sent to Vic, are right out of the service manual. Once you have the assembly disconnected and down , you do need to be careful, releasing the tabs that hold the board in place on the control assembly., as long as you're careful you should be fine. Good Luck and Thanks Read More...
Terry April 11, 2012 for Model Number LFC25760SB The display showing the freezer/refrig temp only seems to work on the freezer side. The refrigerator side doesn't even light up. The part is AP4439660 but can I be sure that is what is wrong?
1 Answer Hello Terry. If there is power coming to the display board 6871JB1374B, but only half of the board works, and there are no loose connections, you will need to replace the display board. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Vic December 14, 2011 for Model Number LFC25760SW I purchsed the pcb assembly / display board for this model refrig. Please illustrate installation procedure. I removed the defective one by forcing it out on an angle from the top cover. Thank you.
1 Answer Hello Vic. 1. First, remove all shelves in the refrigerator, than removethe Refrigerator control Box by loosening 2 screws. 2. Remove the Refrigerator Control Box by pulling itdownward.3. Disconnect the lead wire on the right position andseparate the lamp sockets. 4. Replace PCB assembly 6871JB1374B. 5. Reinstall in reverse order. Hope this helps. Read More...