1 Answer Garry, this would be caused by a clogged defrost drain. If the refrigerator section back cover panel is removed (appliance power cord removed first) the evaporator drip tray can be accessed to clear it out with hot tap water. Once it is clear and does not hold water, the refrigerator drain tube DA97-04049D near the compressor would need to be replaced as well as it will likely cause this failure again. The freezer drain tube DA97-04049D would need to be inspected as well. The drain tube duck bill becomes tacky and holds dust. Regular cleaning of the condenser coils can help to prevent this issue. Read More...
Gary June 26, 2011 for Model Number RS2534WW What should the resistance reading be across this unit when using a digital multi-meter. My present one has a reading of infinity instead of something in the low K range. Should it be close to 0?
1 Answer Hi Gary. I tried to research the information you need. The manufacture does not supply us with the exact value you need. Yes you should set your digital ohm meter to its lowest ohm setting. The heater should give a sort of low ohm reading from .5 to 1.5 ohms. The wire heater needs resistance and as long as it has a relatively low value, and not infinity (open). As long it is not open then you should be ok. I hope this helps. Thank -you. Read More...
Diego April 25, 2011 for Model Number RS2544SL What does this part do? Does it melt the ice that builds up in that location?
1 Answer Hello Diego. This part melts the ice for the drain assembly. If your drain is feezing over, this will resolve the problem. Hope this helps. Read More...