Sue July 12, 2026 for Model Number RS263TDBP/Xaa Ice make makes and dumps ice into the bin, but the ice cube tray seems to hold a cube or two. When the water runs in to refill cube tray, it overflows and causes cubes to freeze together in the catch bin. Does this indicate an ice maker replacement? I have unplugged the refrigerator and let it reset overnight, as well. The problem continued.
1 Answer Sue, This issue would most likely be caused by a faulty icemaker which would need to be replaced. Read More...
Louis G February 21, 2026 for Model Number RS261MDWP/XAA My ice maker fills with water,then about a minute or two it dumps the water out into ice box.
Lois August 23, 2023 for Model Number DA97-08059a My ice maker is making ice and dumping but there is a thin layr of ice on top of the cubes and the ice comes out in clump. Why?
1 Answer Lois, You will want to check for water leaking from the icemaker down on the already made cubes in the bin. This sounds like the icemaker may need to be replaced. Read More...
Deek May 05, 2023 for Model Number QN43Q60BAFXZA I replaced the ice maker assembly with your part DA97-08059A, how long before I know if this has fixed my issue of no ice being made/produced at all. Could it be another issue? Thanks
1 Answer DeekFor a proper diagnosis, we would need you to please verify the model number from the units' I.D. tag since it will not come up for us as a valid model number. Read More...
Fred May 02, 2023 for Model Number RF267ABRS/XAA-0000 I am replacing the ice maker assembly (DA97-05422A) on my Samsung refrigerator. Do I need to reset the new one after installing it?
1 Answer Fred,You shouldn't have to do anything. After installation give the ice maker 24 hours to start producing ice. Read More...
Kevin April 29, 2023 for Model Number RS25J500DSR/AA The ice maker stopped making ice. There is a wire that is hanging down into the ice tray. The spongee tip of it has been severed from the wire itself. Is it possible to replace the wire WITHOUT replacing the entine ice maker assembly?
Jon December 30, 2021 for Model Number Samsung RS261MDRS/XAA 01 Icemaker just let water through fills buck and discharge chute then freezes. New Ice Maker?
1 Answer Jon, If the water did not stop filling then test to see if there is power to the valve and if there is constant power to it then yes the icemaker would need to be replaced. If there is not then the valve will be the issue. Read More...
Bob October 25, 2020 for Model Number RS25H5000WW/AA-0000 After I install the new icemaker, do I need to pull the sensor arm down that touches the ice as the bin fills up. In my old frig, this arm would be pushed up by the ice when the bin was full. That would shut the icemaker off until ice was used.
Rick September 14, 2020 for Model Number DA97-08059A How do you disconnect and reconnect the water feed when replacing the ice maker on a Samsung Refrigerator? The video shows disconnecting and reconnecting the electrical but not the water feed?
1 Answer Rick, the water feed should be free-floating and should not be connected to the ice maker. Read More...
Dan May 02, 2020 for Model Number RS263TDBP/XXA The ice maker is making ice but not harvesting into the bucket, I have to use the reset button on the ice maker to drop the ice. The freezer is cold enough. Could it be the sensor that is on the tray?
1 Answer Dan, as long as the internal temperature of the freezer is verified as being under 10°F (ice cream is firm at 0°) using a thermometer, then the most likely failure is the ice maker DA97-08059A. Read More...